43
Setting the Number of Rings
The ring time setting allows you to set the number of rings the caller hears before your answering system plays the
outgoing message. You can set the ring time to answer after six, nine, or twelve rings. If you enable the Toll Saver
(TS) setting, the answering system picks up after two rings if you have new messages, and after four rings if there
are none. This way, if you make a long distance call to check your messages, you can hang up after the second ring
to avoid long distance billing charges.
From the handset:
Press
[menu/clear]
. Select the ANSW. SETUP menu, and then the RING TIME submenu.
Move the cursor to select a ring time (TOLL SAVER, 6 TIMES, 9 TIMES, or 2 TIMES).
Press
[select/ ]
. You will hear a confirmation tone.
Setting the Day & Time
If you do not set the clock on your answering system, your messages may not have the correct time and day stamp.
From the handset:
Press
[menu/clear]
.
Move the cursor to ANSW. SETUP and press
[select/ ]
.
Move the cursor to DAY & TIME and press
[select/ ]
.
Use
[ ]
and
[ ]
to select the day of the week, and press
[select/ ]
.
Use the number keypad (
[0]
through
[9]
) to select the hour and minutes.
Use
[ ]
and
[ ]
to select AM or PM, and press
[select/ ]
. You hear a confirmation tone.
)
2)
3)
)
2)
3)
4)
5)
6)
Summary of Contents for WDSS 5335 Series
