USING A REPEATER CHANNEL
UHF CB Repeaters are used to retransmit or relay your signal. Repeaters
will extend the range of your radio and overcome the shielding effect
caused by solid obstructions.
In normal Simplex operation, your radio transmits on one particular
frequency and receives on that same frequency. If there is a barrier
(i.e. a Tall Building) that partially blocks your transmitted signal, the
possibility of the other radio receiving the signal is very slim. Valleys,
metallic structures, etc., tend to act as a screen between radios.
Standard Operation without the aid of a Repeater Station
Operation with the aid of a Repeater
With Duplex operation, the signal coming from your radio is received by
the Repeater station and then re-transmitted at the same time on another
channel.
Your
UH-050XR
is designed with duplex capability on Channels 1 to 8.
When any of these channels are set to operate in duplex mode during
transmission, the
UH-050XR
automatically sends the signal at a frequency
30 channels above the original in order to access the repeater station.
After transmitting, the radio reverts back to its original operating frequency.
For example:
1. CH01 is on Duplex Mode
- will Receive on CH01 but Transmit on CH31
2. CH02 is on Duplex Mode
- will Receive on CH02 but Transmit on CH32, etc....
Refer to Duplex Operating Mode table on the last page.
9
