S E T T I N G U P Y O U R P H O N E
R a i s i n g t h e A n t e n n a
Before using your phone, be sure to raise its antenna to the vertical position.
C o n n e c t t h e b a s e u n i t
If you want to install the base unit on the wall, see page 7.
1.
Connect the telephone line cord to the
TEL LINE
jack and to a telephone outlet.
2. Connect the AC adapter to the
DC IN 9V
jack and
to a standard 120 V AC wall outlet.
3. Set the base unit on a desk or tabletop and place
the handset on the base unit. Then raise the
antenna to a vertical position.
Place the power
cord so it does not
create a trip hazard
or where it could
become chafed and
create a fire or
electrical hazard.
A d j u s t i n g R i n g e r / V o l u m e C o n t r o l s
▼
Ringer Tone and Volume
1.
While the phone is not in use, press
volume
.
2. The phone has two ringer tones, each with two volume levels.
Press
volume
again until you hear the ringer tone and volume level you want.
▼
Setting the Handset Earpiece Volume
1.
While you are on a call, press
volume
.
2. The phone has four receiver volume levels, Low, Medium, High, and Maximum. Press
volume
again until you hear the volume level you want.
When you hang up, the phone keeps the last volume setting selected.
S E T T I N G U P Y O U R P H O N E
[ 9 ]
Route the cord
To AC outlet
AC adapter(supplied)
To TEL LINE
To DC IN 9V
Telephone line cord
(supplied)
To telephone outlet
SETTING
UP
YOUR
PHONE
TRU241_2.4GHz 5/22/00 4:39 PM Page 9
