Telephone Operation
Redial
This unit redials up to 32 digits. To automatically
redial the last number you called:
1. Pick up the handset and wait for a dial tone.
2. Press the redial button.
Flash - Call Waiting
If the call Waiting tone sounds while you are on
a call -
Australia:
Press
flash
then
2
to switch between
callers.
New Zealand:
Press the
flash
button to switch
between callers.
NOTE
For ‘Call Waiting’ to operate you must
subscribe to this service through
your local telephone company.
If you do not have this service, then
pressing the flashing button during
a call may disconnect the caller.
Earpiece Volume
You may control the listening level with the
volume switch on the bottom of the handset. It
has 3 levels: lo, mid, and high.
Ringer Volume
You may control the ringer volume level with the
switch located above the touch tone pad on the
handset.
= ringer tone will be loud
= ringer tone will be low
= telephone will not ring
Troubleshooting Tips
No dial tone.
• Press and release the hook switch. Check
the hook switch: Does it fully extend when
the handset is lifted from the cradle?
Phone doesn’t ring.
• Make sure RINGER switch (located on the
handset) is set to loud or low.
• Are you using too many phones on one
line? (The total REN of all phones on the
same line should not be greater than the
maximum REN for your calling area. REN
number is located on the cabinet bottom).
Other party cannot hear you.
• Make sure phone cord is securely plugged
in.
• Make sure extension phones are on the
hook at the same time you’re using the
phone. It is normal for the volume to drop
when additional extension phones are
used at the same time.
• This is normal feedback due to handset
volume level being set to maximum.
General Product Care
To keep your telephone working and looking
good, follow these guidelines:
• Avoid putting the phone near heating
appliances and devices that generate
electrical noise (for example, motors or
fluorescent lamps).
• DO NOT expose to direct sunlight or
moisture.
• Avoid dropping and other rough treatment
to the phone.
• Clean with a soft cloth.
• Never use a strong cleaning agent or
abrasive powder because this will damage
the finish.
• Retain the original packaging in case you
need to ship the phone at a later date.
One-year limited warranty
UNIDEN FP1100 Corded Telephone
IMPORTANT: Satisfactory evidence of the original
purchase is required for warranty service
Please refer to our Uniden website for any details
or warranty durations offered in addition to those
contained below.
Warrantor:
The warrantor is either Uniden Australia
Pty Limited ABN 58 001 865 498 (“Uniden Aust”) or
Uniden New Zealand Limited (“Uniden NZ”) as the
case may be.
Terms of Warranty:
Uniden Aust/NZ warrants to
the original retail purchaser only that the FP1100
(“the Product”), will be free from defects in materials
and craftsmanship for the duration of the warranty
period, subject to the limitations and exclusions set
out below.
Warranty period:
This warranty to the original
retail purchaser is only valid in the original country
of purchase for a Product first purchased either in
Australia or New Zealand and will expire one (1) year
from the date of the original retail sale.
If a warranty claim is made, this warranty will not
apply if the Product is found by Uniden to be:
(A) Damaged or not maintained in a reasonable
manner or as recommended in the relevant
Uniden Owner’s Manual;
(B) Modified, altered or used as part of
any conversion kits, subassemblies or any
configurations not sold by Uniden Aust or
Uniden NZ;
(C) Improperly installed contrary to instructions
contained in the relevant Owner’s Manual
(D) Repaired by someone other than an
authorized Uniden Repair Agent in relation
to a defect or malfunction covered by this
warranty; or
(E) Used in conjunction with any equipment,
parts or a system not manufactured by
Uniden.
Parts Covered:
This warranty covers the Product
and included accessories.
User-generated Data:
This warranty does not cover
any claimed loss of or damage to user-generated
data (including but without limitation phone
numbers, addresses and images) that may be stored
on your Product.
Statement of Remedy:
If the Product is found not
to conform to this warranty as stated above, the
Warrantor, at its discretion, will either repair the
defect or replace the Product without any charge for
parts or service. This warranty does not include any
reimbursement or payment of any consequential
damages claimed to arise from a Product’s failure to
comply with the warranty.
Our goods come with guarantees that cannot be
excluded under the Australian Consumer Law.
You are entitled to a replacement or refund for a
major failure and for compensation for any other
reasonably foreseeable loss or damage. You are also
entitled to have the goods repaired or replaced if the
goods fail to be of acceptable quality and the failure
does not amount to a major failure.
This warranty is in addition to and sits alongside
your rights under either the COMPETITION AND
CONSUMER ACT 2010 (Australia) or the CONSUMER
GUARANTEES ACT (New Zealand) as the case may
be, none of which can be excluded.
Procedure for obtaining warranty service:
Depending on the country in which the Product was
first purchased, if you believe that your Product does
not conform with this warranty, you should deliver
the Product, together with satisfactory evidence
of your original purchase (such as a legible copy
of the sales docket) to Uniden at the addresses
shown below. You should contact Uniden regarding
any compensation that may be payable for your
expenses incurred in making a warranty claim. Prior
to delivery, we recommend that you make a backup
copy of any phone numbers, images or other data
stored on your Product, in case it is lost or damaged
during warranty service.
UNIDEN AUSTRALIA PTY LTD
Service Division
345 Princes Highway,
Rockdale, NSW 2216
Phone: 1300 366 895
Email: [email protected]
UNIDEN NEW ZEALAND LTD
Service Division
150 Harris Road, East Tamaki
Auckland 2013
Phone: (09) 273 8377
Email: [email protected]
