FP1100
Corded Telephone
Owner’s Manual
Visit the our website at:
www.uniden.com.au
for Australian model or
www.uniden.co.nz
for New Zealand model
(c) 2009 Uniden Australia Pty Limited/
Uniden New Zealand Limited
Printed in PRC
Important Safety Information
Introduction
Your telephone is designed to give you flexibility
in use and high quality performance. To get the
most from your new telephone, we suggest
that you take a few minutes right now to read
through this instruction manual.
CAUTION: When using telephone
equipment, there are basic safety
instructions that should always be
followed. Refer to the IMPORTANT
SAFETY INFORMATION provided
with this product and save them for
future reference.
NOTE: This phone uses Touch-Tone
dialing service only. For this telephone
to function properly, you must use
Touch-Tone service available through
your local telephone company.
Hearing Aid Compatibility (HAC).
Before You Begin
Important Installation
Information
• Never install telephone wiring during a
lightning storm.
• Never install telephone jacks in wet
locations unless the jack is specifically
designed for wet locations.
• Never touch non-insulated telephone
wires or terminals, unless the telephone
line has been disconnected at the network
interface.
• Use caution when installing or modifying
telephone lines.
• Temporarily disconnect any equipment
connected to the phone such as faxes,
other phones, or modems.
Handset Layout
Redial
Button
RINGER
Volume
Switch
Flash
Button
Earpiece
Volume
Switch
Installing the Phone
Your telephone should be placed on a level
surface such as a desk or table top, or you can
mount it on a wall. A desktop/wall mounting
pedestal is built into the base of the phone.
1. Slide the RINGER volume switch (on the
handset) to the desired volume.
2. Set the earpiece volume switch (on the
handset) to the desired listening volume.
3. Plug the telephone line cord into a modular
wall phone jack.
4. Store the extra cord in the grooves in the
base.
Wall Mount Installation
Your telephone may also be mounted on a wall
plate (not included).
NOTE: To prevent the handset from
falling out of the cradle while the
phone is hanging on the wall, you
must reverse the handset hook
(located on the base).
1. Push the handset hook up and out of the slot
on the base with your thumb, rotate the hook
180°, and replace it back in the slot.
2. Plug the telephone line cord into a modular
wall phone jack.
3. Slip the mounting holes on the base over
the wall plate posts and firmly slide the unit
down into place (wall plate not included).
WARNING:
TO
PREVENT FIRE
OR ELECTRICAL
SHOCK HAZARD,
DO NOT EXPOSE
THIS PRODUCT
TO RAIN OR
MOISTURE.
CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER (OR BACK).
NO USER SERVICEABLE PARTS INSIDE. REFER
SERVICING TO QUALIFIED SERVICE PERSONNEL.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: