DIRECT WALL MOUNTING
If you do not have a standard wall plate, you can mount
your phone directly on a wall. Before mounting your phone,
consider the following:
•
Select a location away from electrical cables, pipes, or
other items behind the mounting location that could cause
a hazard when inserting screws into the wall.
•
Make sure the wall material can support the weight of the
base and handset.
•
Use the #10 screws included with the wall mount adapter kit.
1) Insert 2 mounting
screws 3-15/16 inches
apart. Allow about 3/16
of an inch between the
wall and screw heads
for mounting the
phone.
2) Follow “Standard
Wall Plate Mounting”
steps 1 through 4 on
page 4.
3) Plug one end of the short telephone cord into the
TEL LINE
jack on the base. Put the cord inside the molded channel on
the bottom of the base.
4) Place the base on the screws and push down until it’s
firmly seated.
5) Plug the AC adapter into a standard 120 VAC wall outlet.
DO NOT use an outlet controlled by a wall switch.
6) Before you plug the other end of the telephone cord into the
modular jack on the wall, charge the battery (refer to
“Charging the Battery Pack,” page 6).
5
SETTING
UP
!
NOTE: DO NOT use an outlet
controlled by a wall switch.
!
NOTE: Use ONLY the
Uniden AC adapter
supplied with this phone.
CAUTION
Before you plug the other
end of the telephone cord
into the modular jack on
the wall, charge the
battery. Refer to “Charging
the Battery Pack,” page 6.
