6
Page
To locate the handset (while it’s off the base), press
find handset
on the base. The handset beeps for 60
seconds.
Paging is canceled when pressing any key,
find handset
on the base or return the handset to the
base.
Flash and Call Waiting
If you have “call waiting” service and a call waiting tone sounds while you are
on a call, press
flash
to accept the waiting call. There is a short pause, then
you will hear the new caller. To return to the original caller, press
flash
again.
NOTE
: You must subscribe through your local telephone company to receive
Call Waiting Service.
Storing a Phone Number in Memory
Your EXP2240 Series has 10 memory locations for storing important telephone
numbers.
1) Remove the handset from the base.
2) Press
m
. The
talk/batt low
LED flashes.
3) Enter the phone number, up to 16 digits. If a pause is needed during the
dialing sequence, press
redial/p
to insert a pause. Each pause counts as a
digit and represents a two second delay in time between digits as they are
sent.
4) Press
m
again.
5) Enter the memory location (0-9) on the keypad. Memory 1 is reserved for
RocketDial
. You can store data in this location by pressing 1. A tone indicates that the number is
stored. If you enter a number in a location that has a previously stored number it will overwrite the
existing number without warning.
NOTES
: • The pause button counts as one digit. Pressing
redial/p
more than once increases the
length of pause between numbers.
•
You have 30 seconds after pressing
m
to enter the number you wish to store. Otherwise,
the handset will beep rapidly.
•
You cannot store numbers in
RocketDial
.
Dialing a Stored Number
Using the memory location features
1) Press
talk
, then press
m
.
2) Enter the memory location (0-9) on the keypad. The stored number automatically dials.
NOTE
: If you select a memory location that does not have a stored number, the handset will beep
rapidly and the phone will not dial.
EXP2240 1/18/2 10:50 AM Page 6