3
4) Place the handset in the base with the keypad facing forward.
NOTE: For optimum performance use only the Uniden Battery
(BT-904) supplied with your phone.
Replacement batteries
are also available through the Uniden Parts Department at
(800) 554-3988, Monday through Friday from 8:00 a.m. to
5:00 p.m. or online at
www.uniden.com
Low Battery Alert
When the battery pack is very low and needs to be charged, the phone is programmed to
eliminate functions in order to save power. If the phone is not in use, the
talk/batt low
LED
flashes when the battery pack is low.
If the phone is in use, the
talk/batt low
LED flashes and the handset beeps. Complete your
conversation as quickly as possible and return the handset to the base for charging.
NOTE:
•
Even when the battery pack is not being used, it will gradually discharge over a
long period of time. For optimum performance, be sure to return the handset to the
base unit after each telephone call.
•
Dial mode setting, last number dialed and numbers stored in memory locations
(including RocketDial), are retained for up to 1 minute while you replace the
battery pack.
Cleaning the battery charging contacts
To maintain a good charge, it is important to clean the charging contacts on the
handset once a month.
Using water only, dampen a cloth to clean the charging
contacts. Then make sure to go back over the charging
contacts with a dry cloth before returning the handset to the
base to charge.
Caution: Do not use paint thinner, benzene, alcohol, or other
chemical products. Doing so may discolor the surface of the
telephone and damage the finish.
C. Connect the base unit
1) Connect the AC adapter to the
DC IN 9V
jack
and a standard 120V AC wall outlet.
2) Set the base unit on a desk or tabletop, and
place the handset in the base unit.
3) Make sure the
charge/in use
LED illuminates.
If the LED does not illuminate, check to see that
the AC adapter is plugged in and the handset
makes good contact with the base charging
contacts.
NOTICE
:
Place the power cord so it does not
create a trip hazard or where it could
become chafed and create a fire or
electrical hazard.
NOTE
:
•
Use only the supplied AD-0001 AC adapter. Do not use any other AC adapter.
•
Connect the AC adapter to a continuous power supply.
•
Place the base unit close to the AC outlet so that you can unplug the AC adapter
easily.
After installing the battery pack in the handset, charge your handset at least
15-20 hours
before plugging into the phone line
.
Route the cor
Route the cord.
d.
Route the cord.
find hs
EXP971 9/10/03 5:52 PM Page 3
Summary of Contents for EXP 971 Series
Page 1: ......
