4
4) Charge your handset at least
15-20 hours before plugging the phone line
.
5) Once the handset battery pack is fully charged,
connect the telephone line cord to the
TEL LINE
jack and a telephone outlet. If your
telephone outlet isn’t modular, contact
your telephone company for assistance.
D. Mount the base unit on a wall
Standard wall plate mounting
This phone can be mounted on any standard wall plate.
1) Plug the AC adapter to the
DC IN 9V
jack.
2) Plug the AC adapter into a standard 120V AC wall
outlet.
3) Plug the telephone line cord into the
TEL LINE
jack.
4) Plug the telephone line cord into the telephone outlet.
5) Align the mounting slots on the base with the
mounting posts on the wall. Then push in and down
until the phone is firmly seated.
Direct wall mounting
If you don't have a standard wall plate, you can mount your phone
directly to the wall. Before doing this, consider the following:
•
Avoid electrical cables, pipes, or other items behind the mounting
location that could cause a hazard when inserting screws into the
wall.
•
Try to mount your phone within 5 feet of a working phone jack to
avoid excessive cord lengths.
•
Make sure the wall material is capable of supporting the weight of
the base and handset.
•
Use #10 screws (minimum length of 1-3/8 inches) with anchoring
devices suitable for the wall material where the base unit will be
placed.
1) Insert two mounting screws into the wall, (with their appropriate anchoring device), 3-15/
16 inches apart. Allow about 1/8 of an inch between the wall and screw heads for
mounting the phone.
2) Refer to steps 1 through 5 above to mount the telephone.
E. Choose the dialing mode
Most phone systems use tone dialing. However, some phone systems (such as in rural areas)
still use pulse dialing. Your Uniden phone supports both tone and pulse dialing. The default
setting is tone dialing. If your phone system uses pulse dialing, follow the steps below to
change the dialing mode:
1) In standby mode, press and hold the
flash
key until you hear a confirmation tone.
2) Press the
#
key to set your phone for pulse dialing. You will hear a confirmation tone.
If you need to reset your phone to tone dialing, press and hold the
flash
key until you hear the
confirmation tone. Then press the
*
/tone
key to restore the tone setting.
NOTE:
• Make sure your battery pack is fully charged before choosing the dial mode.
• If you are not sure of your dialing system, make a trial call. If the call
connects, leave the setting at tone dialing. Otherwise, set for pulse dialing.
Modular
1
2
3
4
5
5
up077.fm Page 4 Thursday, December 14, 2006 2:31 PM