background image

Channels 15 

GMRS/7 

FRS

Sub Codes 

38 Sub-Audible Tones

 

83 DCS Codes

Operating Frequency  UHF 462.5500 - 467.7125 MHz
Power Source 

NiMH Battery Pack (BP40)

Range 

Channel 1-7 up to 28 miles

 

Channel 8-14 up to 5 miles

 

Channel 15-22 up to 28 miles

Battery Life 

12 Hours typ. - 

 

NiMH Battery Pack

 

(5/5/90 duty cycle) 

Frequency Chart

Ch. Freq. 

Cross Ref. 

Ch. Freq. 

Cross Ref.

1  462.5625  FRS & GMRS 1 

12  467.6625  FRS 12

2  462.5875  FRS & GMRS 2 

13  467.6875  FRS 13

3  462.6125  FRS & GMRS 3 

14  467.7125  FRS 14

4  462.6375  FRS & GMRS 4 

15   462.5500  GMRS 11

5  462.6625  FRS & GMRS 5 

16   462.5750  GMRS 8

6  462.6875  FRS & GMRS 6 

17   462.6000  GMRS 12

7  462.7125  FRS & GMRS 7 

18   462.6250  GMRS 9

8  467.5625  FRS 8 

19   462.6500  GMRS 13

9  467.5875  FRS 9 

20   462.6750  GMRS 10

10  467.6125  FRS 10 

21   462.7000  GMRS 14

11  467.6375  FRS 11 

22   462.7250  GMRS 15

CTCSS Chart (Hz)

Code Freq. 

Code Freq.

oF OFF 

20 131.8

1 67.0 

21 136.5

2 71.9 

22 141.3

3 74.4 

23 146.2

4 77.0 

24 151.4

5 79.7 

25 156.7

6 82.5 

26 162.2

7 85.4 

27 167.9

8 88.5 

28 173.8

9 91.5 

29 179.9

10 94.8 

30 186.2

11 97.4 

31 192.8

12 100.0 

32 203.5

13 103.5 

33 210.7

14 107.2 

34 218.1

15 110.9 

35 225.7

16 114.8 

36 233.6

17 118.8 

37 241.8

18 123.0 

38 250.3

19 127.3

Important:  Evidence of original purchase is 
required for warranty service.
WARRANTOR:  UNIDEN AMERICA 
CORPORATION ("Uniden")
ELEMENTS OF WARRANTY:  Uniden warrants, 
for three years, to the original retail owner, this 
Uniden Product to be free from defects in materials 
and craftsmanship with only the limitations or 
exclusions set out below.
WARRANTY DURATION:  This warranty to the 
original user shall terminate and be of no further 
effect 36 months after the date of original retail 
sale. The warranty is invalid if the Product is: 
(A) damaged or not maintained as reasonable or 
necessary, (B) modified, altered, or used as part 
of any conversion kits, sub-assemblies, or any 
configurations not sold by Uniden, (C) improperly 
installed, (D) serviced or repaired by someone 
other than an authorized Uniden service center for 
a defect or malfunction covered by this warranty, 
(E) used in any conjunction with equipment or parts 
or as part of any system not manufactured by 
Uniden, or (F) installed or programmed by anyone 
other than as detailed by the owner’s manual for 
this product.
STATEMENT OF REMEDY:  In the event that the 
product does not conform to this warranty at any 
time while this warranty is in effect, warrantor will 
either, at its option, repair or replace the defective 
unit and return it to you without charge for parts, 
service, or any other cost (except shipping and 
handling) incurred by warrantor or its 
representatives in connection with the performance 
of this warranty. Warrantor, at its option, may 
replace the unit with a new or refurbished unit. 
THE LIMITED WARRANTY SET FORTH ABOVE 
IS THE SOLE AND ENTIRE WARRANTY 
PERTAINING TO THE PRODUCT AND IS IN LIEU 
OF AND EXCLUDES ALL OTHER WARRANTIES 
OF ANY NATURE WHATSOEVER, WHETHER 
EXPRESS, IMPLIED OR ARISING BY 
OPERATION OF LAW, INCLUDING, BUT NOT 
LIMITED TO ANY IMPLIED WARRANTIES OF 
MERCHANTABILITY OR FITNESS FOR A 
PARTICULAR PURPOSE.THIS WARRANTY 
DOES NOT COVER OR PROVIDE FOR THE 
REIMBURSEMENT OVERPAYMENT OF 
INCIDENTAL OR CONSEQUENTIAL DAMAGES. 
Some states do not allow this exclusion or limitation 
of incidental or consequential damages so the 
above limitation or exclusion may not apply to you.
LEGAL REMEDIES:  This warranty gives you 
specific legal rights, and you may also have other 
rights which vary from state to state. This warranty 

is void outside the United States of America and 
Canada.
PROCEDURE FOR OBTAINING PERFORMANCE 
OF WARRANTY:  If, after following the instructions 
in the owner’s manual you are certain that the 
Product is defective, pack the Product carefully 
(preferably in its original packaging). Disconnect 
the battery from the Product and separately secure 
the battery in its own separate packaging within the 
shipping carton. The Product should include all 
parts and accessories originally packaged with the 
Product. Include evidence of original purchase and 
a note describing the defect that has caused you to 
return it.The Product should be shipped freight 
prepaid, by traceable means, to warrantor at:

THREE YEAR LIMITED WARRANTY

Uniden America Service

4700 Amon Carter Blvd. Fort Worth, TX 76155

(800) 297-1023 during regular business hours (CST)

(See www.uniden.com for current hours of operation.)

© 2010 Uniden America Corporation
All rights reserved Printed in Vietnam
UTZZ01051ZZ(0)

SPECIFICATIONS

DCS Code List

REGULATORY INFORMATION

WARNING!

  Read this information before using 

the radio. In August 1996 the Federal 
Communications Commission (FCC) of the United 
States with its action in Report and Order FCC 
96-326 adopted an updated safety standard for 
human exposure to radio frequency 
electromagnetic energy emitted by FCC regulated 
transmitters.
Those guidelines are consistent with the safety 
standard previously set by both U.S. and 
international standards bodies. The design of the 
radio complies with the FCC guidelines and these 
international standards.
Never allow children to operate the radio without 
adult supervision and the knowledge of the 
following guidelines.

WARNING!

  It is up to the user to properly operate 

this radio transmitter to insure safe operation. 
Please adhere to the following:
Use only the supplied or an approved antenna. 
Unauthorized antennas, modifications, or 
attachments could impair call quality, damage the 
radio, or result in violation of FCC regulations.
Do not use the radio with a damaged antenna. 
If a damaged antenna comes into contact with the 
skin, a minor burn may result. Please contact your 
local dealer for a replacement antenna.

Hand-held Operation (Held-to-Face)

This device was evaluated for typical hand-held
(held-to-face) operations with a 1 inch spacing from
the front of the radio. For hand-held operation, the
radio should be held 1 inch from the user's face in
order to comply with FCC RF exposure 
requirements.

Body-worn Operation

This device was evaluated for body-worn operations 
with the supplied belt-clip accessory. In order to 
comply with FCC RF exposure requirements for 
body-worn operations, the radio should only be worn 
with the supplied belt-clip accessory or accessory 
which does not contain metallic components and 
provides a minimum of 3/5 inch separation distance 
between the back side of the radio and the user's 
body.
For more information about RF exposure, please
visit the FCC web site at www.fcc.gov.

RF EXPOSURE INFORMATION

This device complies with Part 15 of the FCC 
Rules. Operation is subject to the following two 
conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference 
received, including interference that may cause 
undesired operation.

Important:

 Any changes or modifications not 

expressly approved by the party responsible for 
compliance could void the user's authority to 
operate this device. Your radio is set up to transmit 
a regulated signal on an assigned frequency. It is 
against the law to alter or adjust the settings inside 
the radio to exceed those limitations. Any 
adjustments to your radio must be made by 
qualified technicians.

To be safe and sure:

•  Never open your radio’s case.
•  Never change or replace anything in your radio 
   except the batteries.
Your radio might cause TV or radio interference 
even when it is operating properly. To determine 
whether your radio is causing the interference, turn 
it off. If the interference goes away, your radio is 
causing it. Try to eliminate the interference by 
moving your radio away from the receiver. If you 
cannot eliminate the interference, the FCC requires 
that you stop using the radio.

Hazardous Environments: 

Do not operate the 

radio in hazardous environments. Explosion or fire 
may result. Do not operate the radio near 
unshielded electrical blasting caps.
Under certain conditions, radios can interfere with 
blasting operations and may cause an explosion. 
Turn your radio OFF to prevent accidental 
transmission when in a blasting area or in areas 
posted: "Turn off two-way radio." Construction 
crews often use remote control RF devices to set 
off explosives.

Care and Safety:

 To clean the radio, use a soft 

cloth dampened with water. Do not use cleaners or 
solvents because they can harm the body of the 
unit and leak inside, causing permanent damage. 
Use a dry, lint-free cloth to clean the battery 
contacts.

 Tone  Octal
 No.  Code
 39  023
 40  025
 41  026
 42  031
 43  032
 44  043
 45  047
 46  051
 47  054
 48  065
 49  071
 50  072
 51  073
 52  074
 53  114
 54  115
 55  116
 56  125
 57  131
 58  132
 59  134
 60  143
 61  152
 62  155
 63  156
 64  162
 65  165
 66  172

 Tone  Octal
 No.  Code
 67  174
 68  205
 69  223
 70  226
 71  243
 72  244
 73  245
 74  251
 75  261
 76  263
 77  265
 78  271
 79  306
 80  311
 81  315
 82  331
 83  343
 84  346
 85  351
 86  364
 87  365
 88  371
 89  411
 90  412
 91  413
 92  423
 93  431
 94  432

 Tone  Octal
 No.  Code
 95  445
 96  464
 97  465
 98  466
 99  503
 100  506
 101  516
 102  532
 103  546
 104  565
 105  606
 106  612
 107  624
 108  627
 109  631
 110  632
 111  654
 112  662
 113  664
 114  703
 115  712
 116  723
 117  731
 118  732
 119  734
 120  743
 121  754

LCD Backlight

The LCD Backlight automatically turns ON when any 

key (except the 

PTT

 button) is pressed. The LCD 

illuminates for 10 seconds before turning OFF.

Roger Beep

Roger Beep is a BEEP that is sent to notify the end of 

transmission (both PTT and VOX transmission). 

Roger Beep can be heard through the speaker when 

both Roger beep and Key Beep are set to ON. When 

Roger beep is set to ON and Key Beep OFF, Roger 

Beep will not be heard from the speaker but it will be 

transmitted to your party. When Roger Beep is set to 

OFF, Roger Beep neither be heard nor transmitted.

To turn OFF Roger Beep:
Press and hold the 

VO

   key while turning ON the 

radio.

To turn ON Roger Beep: 
Press and hold the 

VO

   key again while turning ON 

the radio.

RBRC INFORMATION

As part of our commitment to 
protect the environment and 
conserve natural resources, 
Uniden voluntarily participates in 
an RBRC® industry program to 
collect and recycle used Ni-MH 
batteries within the US. 
Please call 1-800-8-BATTERY for information on 
Ni-MH battery recycling in your area. (RBRC® is a 
registered trademark of the Rechargeable Battery 
Recycling Corporation.)

Reviews: