Changing the Digital Security Code
Find Handset
Installing the Beltclip
The digital security code is an identification code used to connect the handset and the base
unit. Normally, setting the code is not necessary. In the rare situation that you suspect
another cordless telephone is using the same security code, you can change the code. To
change the digital security code:
1) De-register all the handsets you have (see “De-register the handset“ on page 26).
2) Register the handsets by following step 2-3 in “Registering the handset“ on page 15.
To locate the handset, press
on the base when the phone is in standby mode.
All registered handsets beep for 60 seconds, and
appears on the handset display.
To cancel paging, press any key on the handset or
on the base.
Insert the beltclip into the holes on each side of the handset.
Press down until it clicks.
Pull either side of the beltclip to release the tabs from the holes.
find handset
find handset
Paging
To attach the beltclip
To remove the beltclip
Headset Installation
Your phone can be used with an optional headset. To use this
feature, insert the headset plug into the headset pack. Your phone is
ready for hands-free conversations. (Headset can be purchased
from a retailer or by visiting the web site. See page 56.)
!
If the battery pack
is completely
drained, the
handset will not
beep when
paging.
[53]
Summary of Contents for DSS7815 +1 Series
Page 1: ...Series Owners Manual OWNER S MANUAL DSS7815 DSS7815 1 ...
Page 61: ...Memory List 60 MEMORY LIST ...
Page 62: ...Memo 61 ...
Page 63: ...Memo 62 MEMO ...
