If you have additional Handsets, repeat the same
process, but at Step 3 select the next Handset
number.
If a handset is registered at any time as
Handset 1, all other Handsets will need to be
registered again from Step 1.
Registering your phone
This additional Handset is able to be used in conjunction with models DSS2115, DSS2155
and DSS2165 cordless telephones.
The new handset needs to be allocated a handset number and registered to the
Main Base
(DSS2115, DS2155 and DSS2165). The Main Base has a telephone cord plugged into it
and also has an Antenna, not to be confused with the additional charger(s).
O
The original handset supplied with the Main Base is already registered as handset 1, this leaves handset numbers 2 - 7 available. It is
very important to allocate each handset a different number to enable functions such as Call Transfer.
Handset
Registration
number
displayed
REGISTER AS
HAND #2
Fig 2.
P
P
DSS2115 Main Base
DSS2105 Charger
DSS2155/DSS2165 Main Base
HANDSET 1
NEW:
1
TOTAL:
1
TALK HIGH 1
The Registration process needs to be completed within
15 seconds, 5 beep tones will indicate that the time has
been exceeded. Please start the process again.
Fig 4.
Charging
On a Call
Fig 1.
4
DIGITAL 900MHz
Fig 3.
After Registration the Handset number is
shown on the Display Screen either during a
call or while the Handset is charging (Fig 4).
Registration Process
Follow this process for each DSS2105 additional Handset that needs to be registered to the Main Base.
1. Remove the Handset from its charger
2. Press on the Handset (Fig 1).
3. DSS2115 and DSS2155 - Press the number 2 (Fig.2) for Handset 2.
DSS2165 - Press the number 3 for Handset 3.
4. Place the Handset in the Main Base Unit (Fig 3), make sure the
in use/charge
LED comes on.
5. Press and hold the Registration button located on the back of the Main Base unit near the DC power jack
(Fig3). Hold the Registration button in until a long beep confirms the Handset has been registered.
