7
test the Connection
Pick up the corded handset from the base. You should hear a dial tone and
the display on the base should show
Talk.
When you get a dial tone, make
a quick test call.
If...
Try...
the display says Check Tel Line or you
don’t hear a dial tone
•
checking the connection
between the base and the
phone jack.
There’s lot of noise or static
•
See page 28 for tips on
avoiding interference.
set up the accessory handsets
Install and Charge the Battery
1. Unpack all handsets, battery packs, and battery covers.
If you need to remove a cover, press in on the notch and
slide the cover down and off.
2. Line up the battery connector with the jack inside the
handset; the connector only fits one way.
3. Push the connector in until it clicks into place; tug
gently on the wires to make sure the battery is securely
connected.
4. Replace the battery cover and slide it into place.
Connect the Charger
1. Use an AC adaptor to connect the power jack on each charger to a
regular indoor (240V AC) power outlet.
2. Place each handset in a charger with the display facing forward. If the
display doesn’t light up, reseat the handset or connect the charger to a
different outlet.
#
Charge all handsets completely (about 15 hours) before using.
test the Connection
Pick up each handset and press
TALK/FLASH
. You should hear a dial
tone and the display should say
Talk
.
If there is noise or static, see page 28 for tips on avoiding interference.