–
4
–
Step 2: Connect the Charger
1
Connect the AC adapter to the
DC
IN 9V
jack and to a standard 120V
AC wall outlet.
2
Set the charger on a desk or tabletop,
and place the handset in the charger
with the keypad facing forward.
3
Make sure the
charge
LED illuminates.
If the LED does not illuminate, check
to see that the AC adapter is plugged in and that the handset makes
good contact with the charger charging contacts.
•
Use only the supplied AD-0005 AC adapter. Do not use
any other AC adapter.
• Place the charger close to the AC outlet so that you can
unplug the AC adapter easily.
4
Charge the handset for 15-20 hours before using.
Step 3: Register the Handset
YOU NEED TO REGISTER THE DCX700 TO THE MAIN BASE BEFORE USE!
1
Be sure the handset battery is fully charged.
2
For DCT746 and DCT748 models (model numbers may vary)
With the main base in standby mode (i.e., not being used), place
the extra handset in the main base to begin registration.
For DCT7488 (corded base model)
1) With the main base in standby mode, press the
MENU
soft key on
the base.
2) Press
/vol/
or
/vol/
on the base to select
H S
R eg i st r at i on
, and then press the
OK
soft key.
3) Base LCD screen will display the following prompt:
-
O n h a nd s et p r es s & ho l d
"
#
"
ke y f o r 2 s ec
4) On the handset, press and hold
#
for 2 seconds. To cancel
registration, press the
CANCEL
soft key on the base.
For compatible models (DCT6 series) (model number may vary)
1)Disconnect the AC adapter.
2)While holding
find handset
(or
intercom
for DCT6485 models),
connect the AC adapter.
Keep pressing the key until the CHARGE LED starts to blink.
3)On the handset, press and hold
#
until you hear beep.
3
While the handset is registering,
Ha nd s et Re g is t er in g
will
appear in the handset LCD. When
Re g is t ra ti o n C om p le te
is
displayed, the handset has been registered to the base.
If
R eg is t ra t io n F a il ed
appears, please try these steps again.
UU869BH_TCX700 OM.fm Page 4 Friday, June 4, 2004 5:22 PM