If there's static on the line
DSL broadband Internet service can
cause static on telephones, but a
DSL
filter
usually solves any problems. To
get a DSL filter, call your DSL provider
or look in any electronics store.
To install the filter, plug the DSL filter
into the wall jack and then plug your
phone into the filter. Make a test call
to see if the noise is gone.
What Else Do I Need to Know?
FCC compliance information
Part 68 information
This equipment complies with Part 68 of the FCC rules and the requirements adopted by the
ACTA. On the bottom of this equipment is a label that contains, among other information, a
product identifier in the format US: 6NYTE##BXXXXXX (where XXXXXX stands for a specific
model number). If requested, this number must be provided to the telephone company.
An applicable Universal Service Order Codes (USOC) certification for the jacks used in this
equipment is provided (i.e., RJ11C) in the packaging with each piece of approved terminal
equipment. A plug and jack used to connect this equipment to the premises wiring and
telephone network must comply with the applicable FCC Part 68 rules and requirements
adopted by the ACTA. A compliant telephone cord and modular plug is provided with this
product. It is designed to be connected to a compatible modular jack that is also compliant.
See installation instructions for details.
The REN is used to determine the number of devices that may be connected to a telephone
line. Excessive RENs on a telephone line may result in the devices not ringing in response to
an incoming call. In most but not all areas, the sum of RENs should not exceed five (5.0). To
be certain of the number of devices that may be connected to a line, as determined by the
total RENs, contact the telephone provider. The REN for this product is part of the product
identifier that has the format US:6NYTE##BXXXXXX. The digits represented by ## are the
REN without a decimal point (e.g., 18 is a REN of 1.8).
If this equipment causes harm to the telephone network, the telephone company will
notify you in advance that temporary discontinuance of service may be required. But if
advance notice isn’t practical, the telephone company will notify the customer as soon
as possible. Also, you will be advised of your right to file a complaint with the FCC if
you believe it is necessary. The telephone company may make changes in its facilities,
equipment, operations or procedures that could affect the operation of the equipment. If
this happens the telephone company will provide advance notice in order for you to make
necessary modifications to maintain uninterrupted service.
If the equipment is causing harm to the telephone network, the telephone company may
request that you disconnect the equipment until the problem is resolved.
Follow instructions for repairing, if any (e.g. battery replacement section); otherwise do not
substitute or repair any parts of the device except as specified in this manual. Should you
experience trouble with this equipment, contact Uniden customer service at 800-297-1023
to arrange repairs. All repairs must be done by Uniden or an authorized agent.
Connection to party line service is subject to state tariffs. Contact the state public utility
commission, public service commission or corporation commission for information. This
equipment is hearing aid compatible.
NOTICE: According to telephone company reports, AC electrical surges, typically resulting
from lightning strikes, are very destructive to telephone equipment connected to AC power
sources. To minimize damage from these types of surges, a surge arrestor is recommended.
DSL filter
Telephone
cord
Telephone
wall jack
DSL filter
Telephone
cord
Telephone
wall jack
