file:///C|/Documents%20and%20Settings/POpitz/My%20Documents/temp/UnidenManBeta/ToneOutMode.html
To determine whether the information on this page applies to your scanner,
see the tags at the bottom of the page.
With the tone out feature, the scanner monitors up to 10 different channels for paging tones
(two-tone sequential, single tone, and group tone). Normally, the scanner monitors each of
the 10 channels in turn. However, if any tone-out channels share the same frequency,
modulator, and attenuator settings, the scanner checks these channels simultaneously.
Configuring Tone Out channels
To configure Tone-Out channels:
1. Go to the
2. Select Tone-Out Setup .
3. Select the Tone-Out channel ( Tone-Out 1 through Tone-Out 10 ) you want to
configure.
4. Select Set Frequencies and choose the frequencies for this channel
5. Select Set Tone and program Tone A and Tone B.
6. Set any of the other properties as you prefer (they aren't required).
Required
Frequencies (
Tone A and Tone B (
Recommended
Name (
)
Optional
Automatic Gain Control (
)
*
)
Alert (
file:///C|/Documents%20and%20Settings/POpitz/My%20Documents/temp/UnidenManBeta/ToneOutMode.html (1 of 4)4/7/2009 10:09:01 AM
