22
Setting Up Your Scanner
the scanner's DC 6V jack (see “Using AC Power” on
Page 23).
WARNING!
Do not connect either adapter to the scanner if non-
rechargeable batteries (such as alkaline batteries)
are installed in the scanner and
REG. ALK. BATT./
NI-MH BATT.
is set to
NI-MH BATT.
, or if you are
unsure of the switch’s position. Non-rechargeable
batteries will get hot and can even burst if you try to
recharge them.
Before you use Ni-MH or Ni-Cd batteries for the first
time, charge them for 14 hours to bring them to a full
charge.
Discharged batteries take about 14 hours to fully
recharge.
Notes:
•
Ni-MH batteries last longer and deliver more
power if you occasionally let them fully
discharge. To do this, simply use the scanner
until it beeps every 15 seconds and
flashes.
•
To prevent damage to Ni-MH batteries, never
charge them in an area where the temperature is
above 113°F (45°C) or below 40°F (4°C).
•
For longer operation, you can also use high-
capacity Ni-MH batteries to power the scanner.
This type of battery takes longer to recharge.
You can get high-capacity Ni-MH batteries at
your local electronics store.
