TROUBLESHOOTING
TROUBLESHOOTING
PROBLEM
SUGGESTION
Answering system does not work
• Make sure the telephone line cord
is plugged in.
• Make sure that the AC Adaptor
is plugged in.
• Make sure the DTAM is turned on.
• There has been a power failure.
Disconnect the telephone line cord,
press the reset button and re-connect
the telephone line cord.
Answering System does not answers
• The memory may be full. Delete some
after 3 rings.
or all of the saved messages.
Messages are incomplete.
• The incoming messages may be too long.
• The memory may be full. Delete some
or all of the saved messages.
No sound on the base unit speaker during • Adjust the volume control on the side of
call monitoring or message playback.
the DTAM. Refer page 26
Cannot record outgoing message (OGM)
• The memory may be full. Delete some or
all of the saved messages.
37
IF your 7100A DTAM unit is not performing to your expectations,
please try these simple steps. If you are still unable to resolve the
problems, contact Uniden Customer Service for assistance.
Continued over....
6
Stop playback and message recording.
7
Record a memo.
81
Change OGM1. After the DTAM beeps, begin your new OGM1.
When you finish, press 6. The DTAM beeps and replays.
82
Play OGM1. If no OGM1 is recorded, the DTAM announces "You
have no announcement one".
91
Change OGM2. After the DTAM beeps, begin your new OGM2.
When you finish, press 6. The DTAM beeps and replays.
92
Play OGM2. If no OGM2 is recorded, the DTAM announces "You
have no announcement two".
After you press 2 or 3 to play messages:
Press
To
1
Replay the previous message
3
Skip to the next message
4
Replay the current message
5
Delete the current message
6
Stop message playback
REMOTE OPERATION
36
REMOTE OPERA
TION
3653 Uniden 7100A Booklet 27/7/98 1:09 PM Page 36
