ENDAT-GX201 USER’S MANUAL
UNICORN COMPUTER CORP.
53
To access this program, insert the Driver Diskette into the floppy disk drive or other bootable
device (such as USB flash disk) and then type the following at the DOS prompt:
¾
A:\REST8139.EXE <ENTER>
1. View
Current
Configuration
This allows you to find the PCI Fast Ethernet adapter current configuration in your system.
2. Set
Up
New
Configuration
Select Set Up New Configuration option from the main menu
The option settings can be changed, the table shown as below:
Option Default
Setting
Other
Available
Settings
Medium Type
Auto Selection
100 Full – Forces to full duplex operation
Flow Control
Tx Enable, Rx Enable
Tx Disable, Rx Disable
Note:
Before setting the adapter for full duplex, make sure the hub switch is also set to full
duplex. Before you activate the switching hub to server connection, make sure the
hub switch and adapter are configured for full duplex.
3. Run
Diagnostics
Running diagnostic tests perform basic function verification for on board LAN adapters.
The basic Diagnostic tests include:
•
EEPROM Test
: EEPROM data read/write test
•
Diagnostics On Board
: Performs on board basic function verification
•
Diagnostics On Network
: To run this test on the network, you will need another
computer set up as a Responder to receive packets from the adapter being tested and
echo them back to the adapter. This checks the adapter’s ability for communication over
the network with another adapter to receive and transmit network packets.
ENDAT-GX201 USER’S MANUAL
UNICORN COMPUTER CORP.
54
Appendix A: FLASH Memory Utility
Using this utility to update the system BIOS from a disk file to the on board Flash memory. Be
aware the improper change of the system BIOS will cause the system to malfunction.
Using utility as follows:
1. Insert the FLASH memory utility distribution floppy diskette in drive A:
2. At the DOS prompt, type A:>AWDFLASH and press <Enter>
AwardBIOS FLASH Utility
V8.24G
C>Phoenix Technologies Ltd. All Rights Reserved
Flash Type –
File Name to Program:
Message:
3. Enter the name of the system BIOS disk file into the "File Name to Program" field.
The following message appears in the "Message" field
4. Do you want to save BIOS (y/n)?
5. To update the FLASH memory from the system BIOS disk file, type Y
6. After complete updating, please re-boot the system (press “
F1
” key)
7. For upgrade BIOS procedure, please refer to our web site:
http://www.unicorn-computer.com.tw
* Please turn off system and clear CMOS data by JBAT1.
* Please restart your system and load setup default /
