- 3 -
P1
- Illuminator Bar with USB Cable
1 pc
P6
- ON/OFF Touch Sensor Switch
with USB Cable
1 pc
P5
- 3.5 x 12 mm
Phillips Head Screw
6 pcs (3 pcs for extra)
(To Scale)
P4
- Connecting Clip
6 pcs
(To Scale)
P2
- Illuminator Bar
5 pcs
P3
- Support Bracket
3 pcs
P7
- AC Adapter
1 pc
P8
- Battery Box
will require 3 AA batteries
(Batteries NOT-included)
1 pc
(Use will be optional)
First Time Battery Installation:
Locate battery compartment for this product.
Use alkaline batteries for maximum performance.
Using a small Phillips head screwdriver – loosen and remove the battery compartment cover screw(s).
Remove battery compartment cover.
Install new batteries only after reading the “ Battery Information NOTICE“ !
Replace compartment cover and secure cover with the cover screw. Do not over tighten and strip out the screw.
IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference. Batteries must be installed / replaced by an adult .
Notice:
1. Remove and replace batteries when the electrical features of this product work slowly or are not functional.
2. Do not mix old and new batteries.
3. Do not mix different types of batteries : Alkaline , Standard ( Carbon-Zinc) , or rechargeable (Nickel-Cadmium batteries).
4. Use Alkaline Batteries for maximum performance.
5. Do not use damaged batteries.
6. Use only batteries of the same or equivalent type as recommended.
7. Install new batteries as per matching the battery polarity guide (+ & - , positive and negative) inside of the battery
compartment. Correct battery polarity installation is critical as to not damage the internal electrical components as well
as insuring the correct functionality of the product.
8. Do not short circuit the battery terminals.
9. Always remove exhausted, leaking, weak, and batteries from long periods of nonuse from the product. Battery leakage
and corrosion can cause damage.
10. Check the battery terminals are clean and bright before installing new batteries.
11. Dispose of old batteries safely and per local battery disposal codes.
12. Do not dispose of batteries into a fire as they may explode or leak.
13. If removable rechargeable batteries are used , they are to be charged under adult supervision.
14. Rechargeable batteries are to removed from the product before they are charged.
15. If you use a battery charger, it should be examined regularly for damage to the cord, plug, enclosure, and other parts.
Do not use a damaged or malfunctioning charger until it is properly repaired.
16. Non rechargeable batteries must not be recharged.
17. Always remove batteries from this product for extended storage and or non-use.
18. Should this product cause , or be affected by, local electrical interference, move it away from other electrical equipment.
Reset (switching off and back on again and or removing and reinserting the batteries) if necessary.
PARTS IDENTIFIER
