Unical TOUCH SCREEN N, User'S And Installer'S Manual

Page: 18 / 44

Touch Screen
18
3.6.5.1 USER MENU – KEYBOARD SETUP
To access the user menu you have to set the user password (modifiable):
0.
From here you can:
•
Set the date and the hour by pressing on “ Clock ” key (it appears on the screen shown in Figure 22);
•
Set the language by pressing on “ Language ”;
• Access to the setup of the keyboard, pressing on “ Parameters ”.
Figure 22. Date and hour page settings
It is possible to change the setup of the keyboard according to the parameters shown in the following table:
N. PARAMETERS NAME UNIT DEFAULT VALUE MINIMUM VALUE MAXIMUM VALUE
1/3 User password Numb 0 0 999
2/3 Idle Backlight intensity % 5 0 100
3/3 Screensaver unlock Psw Numb 0 0 999
Table 3. User’s parameters menu (keyboard setup).
To change the value of a parameter:
• Enter in " Parameters" , use the up and down arrows to scroll through the pages of the parameters, until you find the
desired parameter;
• press on the currently set value;
•
the present value turns red to indicate that it can be changed by using the up and down arrows;
• Select the desired value and press the confirmation tick .
Note: If you press outside the confirmation area, it returns again the previously value.
3.6.5.2 SERVICE MENU
In order to access to the menu, you must set the service password.
From here you can:
•
configure the network, by pressing on the button " Address configuration ";
• configure zones, by pressing on the button " Area Configuration ";
• access to service’s parameters Chillers, Touch Screen and fancoils, pressing on button " Parameters ";
• Access to the alarm history, by pressing on " Alarm list ".
The screens shown are as follows:
1. Address configuration
1.1. Addresses assigns
1.2. Scan network
2. Configuration of zone
2.1. Zone 01
2.2. Zone 02
2.3. Zone xx
3. Maintenance parameters
3.1. Chiller
3.1.1. Chiller 01
3.1.2. Chiller 02
3.1.3. Chiller xx
3.2. Keyboard
3.3. Fancoil
4. Alarm list