9
ace
3- MACHINE INSTALLATION
The machine must be installed on a horizontal plane.
A space of 5 cm (1.9”) should be left all around the machine; and do not obstruct the air inlets on the top of
the machine.
Provide an electricity supply corresponding to the power of the machine, a water supply and a “waste water”
drain.
►
Preparation of the machine
The machine is delivered in a cardboard packing case and is screwed to a wooden pallet.
♦
Unpacking the machine
- Cut the banding with shears.
- Open the packing case and remove the box containing the accessories.
- Unscrew the nuts holding the machine to the palette by tilting the pallet slightly.
- Separate the packing case from the pallet
- Remove the machine from the pallet and install it on wooden blocks.
- Remove the transport screws and washers.
♦
Installing the machine
- Position the machine in its final location, and level it using rubber washers if necessary.
♦
Fitting high feet
Reference UNIC feet NSF:
NM-176
Reference UNIC M8 x 16 bolts:
50402
For fitting the aluminium feet, once the machine is installed in its location:
Screw the 50402 bolts to the aluminium feet, tip the machine onto the front
two feet to screw in the aluminium feet at the base of the rubber feet at the
back, and then do the same operation for bolting the feet to the front.
►
Hydraulic connections
The machine is delivered with a complete connection kit including a stainless steel braided water hose 2 m
length and a drain hose 2m (78.7”) in length with a clamp located in the box of accessories.
- Slide the lower trims toward the front
- Remove the basin grille
- Remove the basin after unscrewing the central screw.
- Remove the right-hand side of the ACE,
- Screw the angled part (3/8’) of the stainless steel braided flexible
pipe to the 3/8G fitting of the water safety filter block and the straight
part (3/8’) on the water softener outlet union.
The water softener must be fed directly by the mains via a shut-off
tap allowing a sufficient flow, Ø 8cm (3.1”) min.
Do not forget the seals. An opening in the chassis allows the hose
to pass through
- Put the softener in the flush position.
- Open the supply tap.
- Run a flush of the softener.
- Put the softener in the working position.
- Fit the drain hose on the fitting located in the centre of the machine
- Check for leaks, and make sure that the drain tube allows a flow to
the main drain without any reverse slope.
- Refit the bowl, not forgetting the seal which must be between drain
block and the basin, and not between the central screw and the basin.
- Refit the trims and the basin grille.