ELP50 Low Profile Manual
Original instructions
2020
16
14)PIPE ADAPTOR KIT RD2311
FITTING INSTRUCTIONS
▪
Dependent upon the size of the pipe to be cut (see illustrations) attach adjustable angle plates RD3328
with cap screws RD4325 and washers RD4205 (4 off each) to the magnet sides. Do not tighten.
▪
Locate the machine on the centreline of the pipe taking care that the magnet is in line with the
longitudinal axis of the pipe.
▪
Switch on the magnet and move the sliding plates down to the outside diameter of the pipe. Tighten the
screws on both sides by hand then check once again that the full length of the moving plates is touching
the pipe at the front and back, fasten the plate securely. Feed the safety strap through the lugs at the
front of the housing, around the pipe and pull tight.
▪
When cutting theholeDO NOT use excessive pressure but rather let the cutter ease into the cutting
surface.
