Unibor CMD400, Manual

Page: 12 / 31

1 2
s
Mounting Of Cutters
• The machine has been made to accept cutters having 3/4” dia. Weldon shanks.
The following procedure is to be used when mounting cutters:
• Lay the machine on its side with feed handles uppermost, ensuring arbor is wound down to its
lowest point to enable access to socket screws RD4066.
• Take appropriate pilot and place through the hole in cutter shank. Insert shank of cutter into bore
of arbor, ensuring alignment of two drive flats with socket screws.
• Tighten both screws using hexagon key.