4
•
If you see any unusual sign or hear any strange sound, switch off your machine and stop working
immediately.
•
Do not forget to remove all wrenches and screwdrivers from your machine after use.
•
Before use, make sure that all screws are tightened securely.
•
Perform maintenance regularly. Before use make sure the machine is in good working conditions
and without any damage.
•
Use only original spare parts for repairs.
•
Using extension pieces or accessories not approved by the manufacturer may cause injuries to the
operating personnel.
•
Use this tool only for work that it is capable of handling. Do not overload your machine or accessories.
Do not attempt to use machine with insufficient power to perform heavy duty work.
•
Do not overload your device. Measure the work load in such way, so it could be done with comfortable
speed.
•
The warranty does not cover damages caused by overloads.
•
Do not expose to extremely high temperatures or direct sunlight.
•
This machine is not design for use in humid environments or under water.
•
If you are not using your machine, store it in a dry and safe place, out of reach of children.
•
Before use make sure that all safety elements work correctly and efficiently. Make sure all moving parts
are in good working conditions.
•
Before use make sure that no part is cracked or stuck.Make sure all parts are attached and assembled as
designed. Beware of all other conditions that may have a negative effect on the proper functioning of your
equipment.
•
If not stated otherwise in this manual, all damaged parts must be repaired or changed.
Fine mechanics
•
Never use a vise to hold your tool.
•
Protect your machine from impact and fall. After you finish your work, place your tool back to the
protective case.
Assembly
•
Do not use your machine unless completely assembled in accordance with the instructions contained in
this manual.
Auto-service Equipment
•
Before you start working on a vehicle, make sure that the parking brake is applied and that the vehicle is
secured against movement.
Power equipment
•
If your machine is equipped with depressed springs, use suitable device to release them slowly and safely.
•
Before throwing the packaging material out, make sure no part is left inside. If so, take it out and install it.
Use the part listing for check-up and the installation drawing for guidance.
ASSEMBLY
5
Three-arm puller assembly
Using pulling cone
•
Pulling cone/wedge is equipped with outer hexagonal piece and nut.
•
When you screw and tighten the puller on the rod of the reverse hammer you may screw the treaded rod as
well as the extension pieces into the object that you intend to pull out.
Using the extension pullers - sample of use
Detailed description of the use of this device is not included in this manual, because the manufacturer /
distributor assumes that the user is experienced in similar type of work. Also according to the applicable
law, this device is considered as a commonly sold and used tool. If the user is unfamiliar with the use of
this device, we recommend finding out more information about using this device at the Department of
work safety.
OPERATION
