8
•
Place the battery in the base as seen on the
picture. Make sure the safety notch in engaged.
•
Press the charge button, located between the
red and green LED diodes.
•
The green LED diode will come on, indicating
the start of the charging process.
•
During charging both LED diodes stay on.
•
If the charging is finished, the green LED diode
comes off and only the red one stays lit,
indicating that the charger is under power.
•
When the charging process is finished, press
the safety notch and remove the battery from
the base.
•
Disconnect the power cable plug from the wall
outlet.
•
If the battery pack is fully charged and the
operational time is significantly shortened, the
battery is damaged and must be changed for
a new one.
Installing and removing the battery pack 3
•
Set the directional switch 2 to the middle position - the switch with the integrated speed control is blocked.
•
Align the fully charged battery with the groove in the handle and slide it in, Make sure that the safety notch
is engaged. You may use slight force to overcome the spring force in order to correctly connect the battery.
•
If you want to disconnect the battery, press the button 10 and remove it.
Selecting the operational mode 6
You may use your impact drill in two modes:
•
Regular rotary drilling: use for screw driving,
steel, wood and plastic hole drilling. The switch
is in its vertical position.
•
Impact drilling: use for concrete and wall impact
drilling. Select the desired mode by turning the
mode switch so the tip of the switch points on
the applicable symbol.
9
Using the SDS - plus system for tool fastening and releasing
•
Your machine is equipped with SDS-PLUS fastening system. The shank of the drill must be cleaned and
lubricated regularly.
•
Place the drill shank to the holder 9.
•
Press the drill bit down and turn it until it engages.
•
Pull the drill to make sure that it is securely fastened.
•
Impact drilling method requires the drill to move few millimetres along its long axis.
•
If you want to remove the drill, slide the fastening socket of the holder back and remove the drill.
Installation of the side handle 8
•
You may set the side handle to either side to accommodate left or right handed persons.
•
Use the machine with correctly installed side handle only.
•
Turn the side handle to release it.
•
Right handed persons: slide the handle socket over the fastening ring behind the handle. Left handle position.
•
Left handed persons: slide the handle socket over the fastening ring behind the handle. Right handle position.
•
Adjust the handle in the most comfortable position and secure it in place by turning.
Setting the drilling depth
•
Install the applicable drill inside your machine.
•
Release the side handle 8.
•
Push the depth setting pole through the opening
in the handle socket.
•
Set the desired drilling depth.
•
Tighten the side handle.
Direction switch
•
Move the direction switch 2 to the right side
to select forward direction (right rotation).
•
Move the direction switch 2 to the left side
to select backward direction (left rotation).
•
Move the switch 2 to its middle position. The
integrated switch is blocked in this position to
ensure safe tool replacement, manipulation or
handling during transport or storage.
•
Always wait until the engine comes to a complete
stop before changing the direction of rotation.
Operational instructions
•
Always follow all safety instructions and regulations.
Switching your machine ON/OFF
•
You may switch your machine on by pressing the switch 1. This integrated switch also serves as a speed
regulator. The more you press the switch the faster the chuck will turn and vice versa.
•
The amount of pressure applied on the switch determines the speed.
•
To stop you machine, simply release the switch. The electric brake will stop the rotation of the chuck
immediately.
