P.4
OPERATION
1. Turn on the audio source (TV or audio component) to which the transmitter is
connected with. The green LED on the transmitter will light up.
2. Select the channel (1 or 2) of the transmitter for best performance in your
location.
3. Press the “POWER” button on the speaker to turn on the speaker. Press the
“AUTO SCAN” button to get the best tuning reception in the speakers. When
the button is pressed, frequency tuning starts automatically and it stops when a
signal is detected.
4.
Volume can be adjusted up
by pressing “+” button or
down by pressing the button
“-“ to the desired listening
level.
NOTE :
a). Keep a distance of the speaker up to 7 meters apart from the transmitter,
and then press “AUTO SCAN” button for the best reception.
b) Whenever you find frequency jam, move your channel switch from one
channel to the other channel (there are two channels for selection) on the
transmitter, and then press the “AUTO SCAN” button again.
6.
You should now be able to place the speakers freely from room to room
without disruption. Should there is any disruption (signal cuts off or carries
distortion), press the speaker’s “AUTO SCAN” button to maximize the best
reception.
If you hear interference from other components, switch on the channel control
