Uneek 4x4 JK-RB-ASM11, Fitting Instructions Manual

Page: 18 / 20

Fit Tyre mount with 2 M12 bolts washers either side
or nyloc nuts. This tyre mount is adjustable in and
out depending on your wheel offset. It is
recommended to try use the setting pushing the tyre
closest to the vehicle first.
The aim is to have the tyre as close to tyre carrier as
possible. It is best if the tyre rests against the tyre
carrier to prevent wobbling of the tyre.
Don’t forget to refit your number plate relocation
bracket and fit tyre.
Make sure you torque up nuts on soft stop and
adjust tyre height or tyre-stick out as needed.
You’re done, enjoy .
Fit RH jerry can mount to RH side of tyre carrier, or
vice versa for LH using M10 Hardware. Then secure
Jerry can holder to mount with M8 hardware.
Depending on your tyre size you can choose to mount
the jerry can closer or further out from the centre of the
tyre carrier.
Remember only to use ratchet straps to secure your
jerry can to the mount.