TWO WAY FUSED ENCLOSURE
8/7L0$7(1LFNHO$%
UL
Ti MATE
80 Installation (
Maximum hull thickness of 65mm
) and Operation.
Qualified/Approved personnel must be used to carry out installation.
Before cutting a hole in the hull, check the hull wall thickness is not greater than 65mm and that the
location of the holes are below the waterline. After cutting and finishing the hole surface, check the ‘body’(5) can be
inserted into the 60mm diameter hole. You are now ready for installation.
Note for cored hulls - After cutting, the exposed surfaces of the hole must be finished to form a solid surface
through it. Thus protecting the internal core of the hull. The wall thickness of the hole should not to less than
5mm-0.25inch. Apply 3M-4200FC sealant to the ‘body’
(5) flange. Slide the body into the hole and from inside the
hull put the ‘compensating ring’
(6) on and screw the ‘securing ring’
(7) up hand tight. Gently tighten the adjustment
adjustment screws (2) so the compensating ring is flush to the hull and the sealant has flowed completely around the
flange and hull. Do
NOT
overtighten the screws as this will squeeze the sealant from the surfaces. Allow the sealant
to solidify and remove surplus. Finally tighten the bolts to 4Nm. / 3ft. lbs. Fit the lamp and assemble the remaining
parts to the UL
Ti MATE 80. Lightly grease the ‘O’
ring and gasket.
Cautionary Label-“Caution: do not operate lights unless totally submerged” must be located by the main
switch.
After completing the installation procedure it is highly recommended to coat the face of the ‘through-hull’
submersible marine light with antifouling and bond them to the anodes or a cathodic protection system.
($57+,1*/,*+7)25&$7+2',&3527(&7,21WLJKWHQWKHHDUWKVFUHZRQWKHVHFXULQJULQJVRWKDW
LWELWHVLQWRWKHVFUHZHGEDUUHO&KHFNWKHUHLVFRQWLQXLW\WRWKHIURQWIDFH
Connect the
exposed
green
cable
on
the light t
o the earth screw
on the securing ring
.
Further wiring instructions can seen on-
ULTIMATE 80-20W LED WIRING
Power
Supply and CONNECTION
20 Watt
12 Volt
LED unit requires 1.60 Amps
-
20 Watt 24 Volt LED unit requires 0.80 Amps
Ensure the the polarity of the
positive
and the negative is correct so that the integral driver
is not damaged
EARTH
SCREW
AND
CABLE
60mm
82mm
122mm
1
2
3
4
5
6
7
8
9
Part Description
Part No
1. 'O' Ring (50mm dia)
02008
2.Adjusment screws
93306
3. Gasket
02009
4. Glass lens
02010
5. Ultimate 80 Body
S02650
6. Compensating Ring
02602-A
7. Securing Ring
02603
8. LED tube
S02605-LED
9: Lamp holder securing ring
02608-B
8/7L0$7(
:/(',167$//
ZZZXQGHUZDWHUOLJKWVFRP
7+(8/7L0$7(5$1*(,6'(6,*1('$1'0$18)$&785('%<81'(5:$7(5/,*+76/7',17+(
8.
ORDERING NUMBERS : -S02860- 12/24vdc
