FCV 5G (Rev. 0) 2
1 . W A R N I N G S
Marking
This equipment complies with the following standards:
EMC: EN 50082-1 * EN 55011 * EN 61000-3-2 * EN 61000-3-3 * IEC 801-2 * IEC801-3 * IEC 801-4
Safety: EN61010-1
The safety standards and precautions listed below must be applied scrupulously during all phases of
use and maintenance of the unit in order to prevent damage to persons, animals and objects.
UNAOHM S.r.l. assumes no liability for any incorrect use of the instrument or any use
different than that specified.
1.1. SAFETY STANDARDS
•
Power the instrument with a voltage which falls within the limits specified in the characteristics
section.
•
Do not use the unit without the relative locks.
•
The instrument is intended for use in covered areas. Therefore do not expose it to rain or
dripping.
•
Do not use the unit in an explosive atmosphere constituted by flammable gases, vapours, smoke
and powders.
•
The instrument can be used in overvoltage Category IIa and pollution grade 2.
•
Do not switch on the unit immediately after moving it from a very cold room to a hot one,
in order to prevent the formation of moisture condensate.
•
Do not obstruct any cooling slots and do not place the unit close to heat sources.
•
Do not apply DC voltage or RF signals greater than those prescribed to the input connectors.
This symbol indicates that the instructions manual must be consulted for
additional information.
This symbol indicates parts of circuit in which dangerous voltage may be present.
