Please read the
Safety Instructions
below carefully.
User Manual
1. One chair can only bear one person's weight, don't let the children who under 5-year-old sit
alone in the chair
；
2. Please put the chair on a flat floor.
3. Please don't sit on the armrest, stand on the chair or use it as a ladder or footsteps in case
they cause some danger
；
4. Don’t use chemical cleaners to clean the chair, but also to avoid contact with acid, alkali and
other corrosive liquids
；
5. Don’t use sharp or hooked objects to scrape the chair and do not get it close to the fire
；
6. To avoid any harm to your fingers, don't insert your finger into the mechanism while sitting
；
adjustment components
；
7. To prevent fall off the chair, please control your gravity when you tilt the swivel chair;
8. Please note that only trained personnel can replace or repair the gas lift.
9. To avoid scraping, do not use the chair on the wooden floor directly.
10. The office chair using environment is home and office.
Assemble Introduction
(The size will be according to regular measurements)
Put the caster into the base by
pressing.
1
Insert the gas lift to the base.
2
Fix the armrest to the seat cushion
with 6pcs (M6*40) screws and
small washers.
3
7
Fix the headrest to the backrest
with 2pcs (M6*20) screws and
cover the headrest decorative
piece, then the chair is assembled.
Accessories list
(The actual size shall prevail; Screws, shims and spring washers
all have one extra for spare)
0
1
2
3
4
5
6
7
8
9
10
cm
Notice: Before installation, please classify the screw and measure screw length to facilitate installation
Armrest Screws / Mechanism Screws (M6*40): 10+1pcs
Backrest Screws(M8*45): 3+1pcs
Fix the mechanism to the seat
cushion with 4pcs (M6*40) screws
and big washers.
Fix the backrest to the seat cushion
with 3pcs (M8*45) screws, spring
washers and big washers.
Put the mechanism into the gas
lift.
4
5
6
Functions
(The size will be according to regular measurements)
Caster: 5pcs
Chair Foot: 1pc
Mechanism: 1pc
Armrest: 1 pair
Seat Cushion: 1pc
Backrest: 1pc
Headrest: 1pc
Small Washers: 7pcs
Spring Washers: 3+1pcs
Gas Lift: 1pc
Big Washers: 8pcs
Headrest Decorative Piece: 1pc
Hexagon Wrench
:
1pc
Headrest Screws(M6*20): 2+1pcs
Front
Front
Press to adjust lifting,
pull out to adjust tilting,
Push in to lock the tilting position,
three tilting positions and
angles for options
Backrest tilt tension
adjustment
Lumbar support height
adjustment
Armrests height
adjustment
Headrest height
adjustment
Contact us:
