9
GETTING STARTED - INITIAL SET UP
TUNING IN DIGITAL TV (FREEVIEW)
IMPORTANT — Please ensure the TV has
reached room temperature before
connecting the power for the first time
1) Connect the mains lead to your electrical outlet
and switch on the TV using the switch next to
where the power cable goes into the TV
2) Connect the RF Cable supplied to the
'RF IN
' on the rear of the TV and connect
the other end of the cable to your TV Aerial outlet
3) Install batteries in the remote control and press
the [POWER] button to turn on the TV.
The ‘Initial Set up-DVBT/Freeview TV’ menu should
now appear. If it does not, please go to step 5.
4) Press [OK] on the remote control whilst ‘Confirm’
is highlighted on screen.
Tuning will now take place. Once it has finished
tuning is complete.
Important
- Due to signal strength variations across the UK for Digital TV, please note that not all of the
channels/services may be available in your region.
Over the coming months as coverage increases, more services and channels may become available.
Every few months, follow point 5 to re-scan for new channels/services,
In the event of poor reception in either Analogue TV or Digital TV (DVB) it may be necessary to install a signal
‘booster’ to enhance reception. For Digital/Freeview TV (DVB) you may need to upgrade your aerial to a High
Gain Digital version.
IMPORTANT - AFTER TUNING DO NOT PRESS ANY BUTTONS FOR 20 SECONDS SO THE CHANNEL
INFORMATION CAN BE STORED.
If you do not see the Initial Setup Screen, follow
the below:
5) Ensure the TV is in DVB mode (press
[SOURCE] on remote control and select DVB)
6) Press the button labelled ‘DVB-MENU’ on remote
control to access settings menu,
Scroll to ‘Channel Search’ and press [OK].
7) The above will appear press [OK] to start search
Auto tune will now take place and set up is complete.
DVB
TV
S-VIDEO
SCART
YPBPR
HDMI
DVD
PC-RGB
19_18 english manual 09.pdf 4. 5. 2009 9:23:39
