Exterior
The casing of the Twister X is steel with a powder paint coating. To clean simply wash with mild soap and warm
water.
Ensure the power is disconnected when cleaning!!!
Maintenance Procedure
Troubleshooting
NOT POWERING UP:
1) Check that power switch is in ON position on and illuminated.
2) Check power cord is securely inserted and locked into Fused Power Entry Module and connected to an
appropriate power source.
3) Verify that the supplied voltage is correct for the fans setup.
4) Check that the appropriate fuse has not failed.
5) Contact Ultratec Special Effects Service Department.
.
FAN NOT TURNING:
1) Check that DMX address is set to correct address being used.
2) Verify that Valid DMX LED is ON solid confirming good DMX signal.
3) Verify that correct DMX address is being sent to unit from DMX console.
4) Check that fan blades are not full of dust / debris. Clean fan blades (Ensure unit is disconnected from any
power source).
5) Look for visual damage to fan blades / motor.
6) Contact Ultratec Special Effects Service Department.
The fan can be controlled locally by using higher numbers in the DMX display.
700-799 will give focused beam/forward fan speed settings of 0-99 which equates to OFF to 100% full on.
800-899 will give wide beam/reverse fan speed settings of 0-99 which equates to OFF to 100% full on.
Note:
Stand Alone Operation overrides DMX
Stand Alone Operation
Note:
The hidden / visible DMX display setting only applies to the valid DMX address ranges. When the unit is
in the Stand-Alone modes (700 - 800 ranges) the display will continuously stay visible regardless of which
display mode it is set to.
5
www.ultratecfx.com
Summary of Contents for TWISTER X
Page 1: ...v 032021 Operators Manual...
