1. Plug the unit into a suitable power source. Turn the main power switch on and it will illuminate if
power is present. The heat up time is approximately 8 minutes before haze can be produced. The
Green LED indicates “heating” when flashing and “ready” when the LED is “solid”. A three-flash pattern
and the fan turning on to full speed indicates an over temperature error.
2. The Haze Rate and Fan Control provides a limited range of control divided into to 8 steps plus OFF
for the assist fan and the haze rate.
The DMX address buttons are used to select the desired operation. Place the DMX address to 600
on the display. The display will stay illuminated indicating this mode is selected. Allow the machine to
heat fully by watching the green LED progress. The ‘tens’ button controls the haze rate. 0 is off, 1-8
runs from low to full (9 is the same level as 8). For minimum Flow Rate use DMX or Optional Hand
Remote Control. The ‘ones’ switch controls the assist fan in the same way, 1-8 is low to full. The Versa
Fan Power Port output will also be adjusted. The fan has a minimum setting and should always run when
the power is applied. The fan only runs faster when haze is requested.
3. 15 Minutes prior to shutting down your Radiance Hazer, adjust your output setting to “0” Doing this
will consume any haze fluid that is still in your distribution feed tubes and processing block. Failure
to do so will result in raw fluid being discharged from your output nozzle when you operate it next
start-up and will help reduce (not stop) the residue buildup.
Note:
Stand Alone Operation overrides DMX and held held remote operation controls.
Radiance Setup
Operating Procedure
After power up, the rear display will momentarily show the code revision levels in the machine and then
display the DMX setting for several seconds. The display will blank after a short period of time. Touching an
arrow key will relight the display. Further activation of the keys will alter the DMX setting.
Stand Alone Operation
1. Insert a 2 or 4 Liter Jug of Ultratec Special Effects Luminous 7 Haze Fluid into the fluid jug holder.
2. Remove the cap and break the foil seal. Insert the fluid pickup tube into the jug and tighten the lid.
Ensure the fluid filter located at the end of the tube sits at the lowest end especially if the machine is
not mounted level.
3. An optional Versa Fan can be controlled at the same rate as the internal fan. Plug a matching
voltage VersaFan into the U-Ground (120 volt) or Neutrik Connector (220-240 volt). It will now vary
with the internal fan control.
Note:
The Versa Fan speed control dial needs to be switched “ON” and set to maximum for proper
operation.
3
www.ultratecfx.com
Hundreds Button
Tens Button
Ones Button
Heating Status
Green LED
Versa Fan
Power Port
