www.ultratecfx.com
5
Operating Procedure
1. The fog machine must be connected to a sine wave voltage supply of 20 Amps free of electrical interference.
2. Open a 4 Litre (1 Gallon) container of Ultratec Special Effects fog fluid and insert the fluid pickup tube into the spout
of the fluid container.
3. Turn ON the Power switch located on the rear panel. The Power switch will illuminate to indicate the presence of
power.
4. After approximately 9 minutes, the fog machine will be fully heated and ready for full output.
5. Set the demand from 1 to 100% using the built-in remote control or through a DMX control network.
Digital Remote Control
Valid DMX
Light
DMX In
DMX Out
LSG Receptacle
(2 amps)
On/Off Switch
Fog On/Off
Value Down (-)
Value Up (+)
Cycle
Menus
Toggle LCD
Brightness
Diagnostics Screen Button
Press “Menu” to exit
(For Service Technician)
Write to Memory
When variables are changed on
the digital remote they are written
to memory after 60 seconds or
when you change screens. The
secondary displays return to the
main menu if inactive for 60
seconds.
