For cleaning carpets and wooden floors, use the steam mop water tank (375mL).
1. If using the mop on rough surfaces or carpets, install the plastic head cover to allow easier
gliding. If using the mop on tiles, smooth surfaces, you can use the mop as is (with just blue
cloth). To snap on the water tank, push the tank down lightly and slide it up until it clicks. To
remove water tank, press and hold the bottom white circle and slide it out. To remove the
handle bar, use a sharp object to press in on the snap hole and pull handle out.
2. With 375mL of water, the mop can typically function for 25 minutes continuously.
3. Once plugged in to the power supply, the light will be lit. The steam ironing machine will begin
to heat up, and the light will remain on for about 35 seconds. Once the light goes out, toggle the
gear to “drag”. At this time, the drag head will start emitting steam and you may begin using the
mop.
4. Drag back and forth on the floor for at least 8 seconds until the area is clean.
5. Do not leave the mop on the same place on wooden/carpet or else the floor surface will be
damaged.
Ironing Use:
*Only use the ironing water tank when ironing.
1. Once plugged in to the power supply, the light will be lit. The steam ironing machine will begin
to heat up, and the light will remain on for about 35 seconds. Once the light goes out, you can
begin to use it.
2. The enclosed brush cover can enhance the infiltration of the steam on thicker fabrics. Make
sure you install the brush before plugging in the machine.
3. The steam iron can be used on horizontal/vertical hanging clothes. The included suction and
clothes hanger can be used on smooth surfaces (ceramic tiles, glass, doors). The hanger can
handle up to 5kg or 11lbs.
