ver.1.1
2
w
w
w
.ul
tral
u
x.bg
2
w
w
w
.ul
tral
u
x.bg
•
Clearing RF Code from controllers
Step
Operation
Instructions
1
Connect the load to the controllers and turn
the power on.
1. The clearing operation should be finished
within 1 minute after the controllers are
powered on. If exceeds the time, can be
powered on again.
2. Pairing operation can be performed within
the remote control range.
2
Press and hold the remote control
“O
FF
”
for 5
seconds. The indicator of the remote control
flashes quickly, means it enters the clearing
code transmission. There is no need to select
the corresponding area when clearing code.
1. Remote controller will automatically exit
code transmission after 60 seconds, or by
pressing any key.
2. If the original remote controller is lost, the
new remote controller can be used for
clearing operations.
3
The load flashes 3 times and return to the
initial state
Clearing coding is finished successfully
•
RF Code learning operation between remote controls
Since each remote controller has its own unique RF code at the time of delivery, when there are multiple
remote controllers in one system, one of them must be selected as a main, and other remote controls
should copy its RF code.
1.
Main
remote control: Press and hold
“ON”
key for 5 seconds. The indicator of the remote control
will flash quickly, means it enters the pairing code transmission status.
2.
New
remote control: Press and hold
“
MODE
”
key for 5 seconds.
3.
Indicator of the new remote control flash three times after successful code learning.
•
Remote control RF code learning from controllers
1.
Turn off the power supply of the controllers.
2.
Press and hold
“
MODE
”
key for 5 seconds until indicator of remote control turns off.
3.
Turn on the power supply of the controllers. Indicator of the remote control flashes three times
after successful code learning.
Note:
The distance from controllers to remote controls should be less than 2 meters. If the distance of
controllers of different zones to remote control is more than 2 meters, upper steps must be repeated for
every zone.
•
Restoring factory settings of remote control
1.
Press and hold “
MODE”
key for 20 seconds until indicator of remote controller turns off.
2.
Press
“
OFF
”
button. Indicator of the remote control flashes three times after successful operation.
