Step 10
Installation of top rail snap
Measure between each secured post and cut top rail
snap 1/16” less than opening size (Dia. 15). Clean cut
areas and apply touch-up paint on all exposed metal.
Snap each top rail snap over the corresponding glass
rail extrusion until properly seated.
After cutting top rail
snap and painting, push
snap down by hand until
properly seated.
DO NOT USE A HAMMER!
Measure, Mark & Cut
Step 11
Installation of top glass inserts
Measure between posts and subtract 2” from overall
measurement. Cut top glass insert to provide clearance at post
clip locations and insert vinyl into top rail extrusion (Dia. #16).
Position glass so gap between panel edge and post is equal on both
ends. Glass gap at ends is typically 3” but can vary depending on
application. Maximum gap must be less than 4”. Insert glass panels
upward into glass insert (Dia. #17A) and swing panel over
opening
in bottom rail glass insert. Pull panel downward until panel is resting
fi rmly inside of bottom glass insert (Dia. 17B). Continue until
all glass panels are installed.
Installation of glass panels
Step 12
Dia. #15
The diagrams and instructions in this brochure are for illustration purposes only and are not meant to replace a licensed professional. Any construction or use of the product
must be in accordance with all local zoning and/or building codes. The consumer assumes all risks and liability associated with the constructon
or use of this product. The
consumer or contractor should take all necessary steps to ensure the safety of everyone involved in the project, including, but not limited
to, wearing the appropriate safety
equipment. Except as contained in the written limited warranty, UltraLox does not provide any other warranty , either express or implied, and shall not be liable for
any damages,
including consequential damages.
© 2015-2016, UltraLox, A WES LLC Company www.ultralox.com
1"
BUTT GLASS
INSERT AGAINST
SUPPORT CLIP
APPROX. 1"
FROM POST
TOP RAIL
TOP INNER
CHANNEL
GLASS
IINSERT
BOTTOM
RAIL ASSEMBLY
1/4" TEMPERED
GLASS PANEL
3" SQ. POST
ASSEMBLY
Dia. #16
**TIP** Window cleaner may ease glass installation into top and
bottom rail assemblies.
Dia. #17A
Dia. #17B
Step 13
GLASS
PANEL
TOP GLASS
INSERT
TOP INNER
CHANNEL
Final Inspection
check to ensure all fasteners are properly secured.
BOTTOM
RECEIVER
TOP RAIL
TOP INNER
U-CHANNEL
FINISHED GLASS SIZE
30-1/4" FOR 36" RAIL
36-1/4" FOR 42" RAIL
