ultracomfort UC342-M, Owner'S Manual

Page: 6 / 16

6
Installation Of Your Power Lift Chair
Model UC342
1. Remove the transformer, hand control,
and power wire from the wooden cross
rail (located behind the lower
outside back) by removing the
white zip tie.
Place transformer on the
fl oor behind the chair.
L.E.D. light
L.E.D. light
From motor
To outlet
115-120V A.C.
DC Power
Bottom view of
Transformer
Transformer
Plug
Install two 9 volt batteries
in transformer for battery
backup (See page 11)
(batteries not included)
PA
TENTED
4. Align the back brackets and the seat
brackets, then push down on the seat back
until they are locked into place.
5. Connect the
red and green
connectors from
the seat back to
the red and green
connectors of the
chair. Red to red
and green to green.
2.Place two 9 volt batteries in transformer as shown.
3. Plug the transformer into a 115-120V 60Hz A.C. outlet and connect the power
cable from the chair into the transformer as shown. Make sure the power cable
is routed under the wooden cross rail.