No power supply
Loose connection of wire cord
Overloading of medium
Low belt tension
Insufficient water
Incorrect wiper position
Excess quantity, insufficient soaking time
Incorrect wiper position
Low voltage
Low belt tension
Motor housing air vents blocked
External heat source
Uneven platform
Motor burnt
Drum / Roller Holder Assembly not cleaned well
Faulty switch
Roller assembly not cleaned well
Roller not cleaned properly after use
Excessive loading/insufficient water
Roller stuck on pin
Grinder does not run
Grinder starts but drum stops suddenly
Grinder is noisy
Takes more time to grind
Grinder overheating
Vibration
Grinder / Drum smells
Grinder stops automatically when it is swiched on
Arm does not lock
Roller not rotating
In case of abnormal operating conditions, contact Ultra Care Centre
Check mains
Contact Ultra Customer Care
Remove medium and add in small quantities
Contact Ultra Customer Care
Add water as required
Check and correct the wiper position as printed on Arm lid
Reduce quantitiy or check manual for correct grinding measures
Check and correct the wiper position as printed on Arm lid
Operate at 230 V Ac 50 Hz
Contact Ultra Customer Care
Use a dry brush to clean air vents
Keep the grinder away from external heat sources
Place the grinder on stable and horizontal platform
Contact Ultra Customer Care
Clean the drum / roller holder assembly
Contact Ultra Customer Care
Unscrew roller and clean under running water
Unscrew roller and clean under running water
Remove excess medium
Unscrew roller pin and clean
TROUBLESHOOTING CHART
PROBLEM
SOLUTION
REASON
9
