Page of 4
3
SAVE THESE INSTRUCTIONS
INSTALLATION
1. When mounting trailer jack it is best to hook up to the tow
vehicle to make sure trailer is secure.
2. Mount jack based on drawing below. All welding must be
performed by a certified welder.
3. Place jack in proper location for trailer application.
4. Weld on entire length of jack where it meets trailer frame
with 3/16" fillet weld.
5. After jack is mounted to trailer, attach handle assembly to
jack. Handle sold separately (Item# 44086)
OPERATION
WARNING:
Drop leg retracts very quickly.
Verify that jack is not supporting load.
If drop leg is extended, operator should place foot on foot plate to control return of drop leg.
Disengage drop leg pin by rotating to the disengaged position.
Using foot, carefully move the drop leg to the desired position.
Engage drop leg pin by rotating it to the engaged position and into the desired adjustment hole.
Verify that drop leg pin is fully inserted into jack by checking for no clearance between the drop
leg pin and the housing. If operator sees clearance, he must adjust the drop leg to fully seat the
pin into the hole location.
It may be necessary to lubricate the drop leg pin assembly, as described in the maintenance
section.
If you are unable to fully seat the pin, do not use the jack.
MAINTENANCE
•
Maintain your Jack.
It is recommended that the general condition of any jack be examined
before it is used. Keep your jack in good repair by adopting a program of conscientious repair
and maintenance. If jack is damaged, discontinue use of the jack.
•
This jack is pre-greased for easy operation. This jack includes a grease zerk for easy lubrication as
needed.
weld shown