KE-4
Installation Manual
QUICK VIEW PROGRAM MENU
SYSTEM RESET
TRANSMITTER PROGRAMMING
Passive / Active Arming
Lock-Unlock-Lock-Unlock
Passive
Active
Passive / Active Locks
Unlock-Trunk-Unlock-Trunk
Passive
Active
Ignition Aouto Door Locks
Lock-Trunk-Lock-Trunk
ON
OFF
Door Lock Pulses
Lock-Unlock-Trunk-Lock
Three Second
.75 Second
Double Pulse
Unlock-Trunk-Unlock-Lock
Double Pulse
Single Pulse
Passive Warning Chirps
Lock-Trunk-Unlock-Trunk
ON
OFF
Reset To Factory Defaults
Trunk-Lock-Unlock-Trunk
Three flashes
Three Flashes
Entering
T
he Program Menu
1) Make sure ignition is in the OFF position.
2) Turn the ignition key ON -
leaving key in the ON position.
3) Press the transmitter buttons in the appropriate sequence.
4) After ten seconds the system will automatically exit Program Mode.
To change a Programmable Feature press the transmitter buttons as follows.
*** Default settings are shown in bold lettering.
To add additional transmitters and delete existing transmitter code(s) from memory.
1)
Turn the ignition
On-Off-On-Off-On-Off-On-Off.
The park lights will flash twice.
2)
Press the Lock button on the transmitters to be programmed.
3)
The park lights will flash once, each time a new transmitter is learned.
*** If this does not happen wait ten seconds and repeat steps 1-3.
Note: Each system can store a maximum of three transmitter codes in memory.
Transmitter Program on “Power Up”
1)
Plug in the module. (Leave the ignition in the Off position).
2)
Press the lock button on each of the transmitters to be programmed.
3)
The park lights will flash once each time a new transmitter code is learned.
Note:
Previous transmitters that are not programmed at this time will deleted from memory.
Reset To Factory Default Settings.
1) Make sure ignition is in the OFF position.
2) Turn the ignition key ON -
leaving key in the ON position.
3) Press the transmitter buttons as follows.
Trunk-Lock-Unlock-Trunk.
4) The system will respond by flashing the park lights three times
The system is now set to factory default settings.
