Harness
TORINO LIGHT
Torino Light Size 1
USC400610001
Torino Light Size 2
USC400610002
Meets
ABNT NBR 15.836/2010
ABNT NBR 15.835/2010
LEIA ATENTAMENTE O MANUAL
ANTES DE UTILIZAR O PRODUTO.
Ultra Safe Comér
cio Importação
Exportação EIRELI
CNPJ: 14.481.552/0001-73
Rua Dom Bento Pickel 191
02544-000 São Paulo SP Brasil
Tel.:
55 11 3858 0263
Fax:
55 11 3858 0867
www.ultr
asafe.com.br
GENERAL INFORMATION
This technical Manual provides essential instructions for proper
use and maintenance of this product. If you have questions or
problems with the product or to better understand this manual,
please contact our Office Coach.
Attention
Specific prior training is essential to the use of this product.
Draw up a rescue or evacuation plan before any activity. Specific
methods increase the safety margin in the activities and work
performed in time.
FALL-FREE ZONE (ZLQ)
It is essential that the user pay attention to minimum free space
required beneath the feet, with the aim of avoiding the shock
against the structure or the ground in case of a fall.
How to calculate free Fall Zone (ZLQ)
The measure of L1 must understand the inside end of a
connector to another of the lanyard (with shock absorber
closed), as shown in figure below.
It is impossible to imagine or list all the possible wrong ways of
use, so only the recommendations expressed in this manual are
allowed. To prolong the life-time and better using this product
we recommend to read, understand and follow the instructions
listed below.
EQUIPMENT INTEGRITY RISKS
Temperature
This product must be used in a temperature between
-40° C and +80° c.
Cuts and abrasion
Avoid friction on rough surfaces and sharp edges during the use.
Chemicals
All chemical products, corrosive materials and solvents can
be dangerous, as they may react with the raw material of the
product. In case of doubt or contact with them, contact with our
Technical Dept.
Exposure to UV rays
Despite the high resistance of polyester to the action of UV rays,
it is recommended not to leave the equipment exposed to same
as the time required for the job.
Fall and impacts important - Dispose
Do not use this product after a fall or an important impact:
even if there are no external or visible signs, a deformation may
restrict its operation or it is possible that an internal attrition
has occurred, thus reducing its resistance.
EVALUATION OF THE INTEGRITY OF THE EQUIPMENT
Inspection
For greater security and control of your equipment, we advise
you to be drawn up a record of inspection for each product.
Inspection of this product shall comprise the following:
A inspeção deste produto deve compreender:
• Seams: attention to loose or worn wires;
• Tapes: attention to cuts, wear by abrasion, damage caused by
use, heat, chemicals, etc;
• Colour: check the loss of colour of ribbons, what can be cause
for product disposal, even if healthy.
• Metal parts: attention to points of rust, wear and cracks.
We recommend that inspections be made PERIODICALLY.
Ultra Safe offers a Equipment inspection full document model.
Download at www.ultrasafe.com.br
STORAGE AND TRANSPORT
In transportation and warehousing, note the following
conditions:
• Keep it in its original packaging or in bags or backpacks (not
waterproof)
• Identified
• Clean
• Dry
• In airy place
• Under room temperature
• Protected from the sun or direct sources of light
• Protected from corrosive or aggressive substances
• Away from the soil, mainly cement
• Never place weight on the equipment
CLEANING AND SANITIZING
To save your product and keep its useful life, we recommend to
always rinsing your equipment and especially when it is used
in aggressive environments (saline aggressive environments,
exposure to gases and others).
Excessive sweating of the body can also damage gradually the
metal parts of this equipment. This is all the more reason for it
to be washed periodically.
Cleaning
Textile products should be washed and rinsed by hand only with
abundant clean water (maximum temperature: +30ºc) and with
a soft brush, if necessary.
Drying
In the initial phase of drying can use a white cloth clean
(without any chemical interference) for the withdrawal of
excess water and then let it dry slowly shade, in well ventilated
place, away from any sources direct heat.
MAINTENANCE, MODIFICATION OR AMENDMENT
Any modification, alteration or repair without consent from the
manufacturer is strictly prohibited, resulting in cancellation of
the warranty and Disclaimer of Company on the product.
USEFUL LIFE
The lifetime, unused, is 5 years from the date textile equipment
manufacturing and components metallic. The life of the product
is the term that expresses the period in which the product
maintains its characteristics physical and mechanical without
considering any kind of wear or use. A severe wear or fall can
limit the lifetime single use only.
WARRANTY
This product follows the accompanying warranty policy product.
In case of doubt or loss of warranty tag, contact us via the
website www.ultrasafe.com.br. If you want to trigger the
warranty against manufacturer’s defects or maintenance of your
equipment please contact sacultrasafe.com.br
This product is guaranteed against any defect of manufacture.
Are excluded from this warranty:
• Normal wear and tear
• Modifications or alterations
• Incorrect storage
• Lack of maintenance and cleaning
• Uses for which this product is not intended
• Oxidation by salinity, perspiration, body storage with the still
damp equipment or wet.
Lanyard length (L1)
Length of absorber
(open)
Maximum distance
between the foot of the
user and the anchor
points (approx. 1, 5 m)
SAFETY HEIGHT
(approx. 1, 0 m)
Pectoral
point
Dorsal
point
