6
These warnings and safety notes are particularly important. Please
follow the instructions for maximum safety; otherwise the charger and
the battery can be damaged or at worst it can cause a re. Also read
the chapter before you begin.
Never leave the charger unsupervised when it is connected to its
power supply. If any malfunction is found, TERMINATE THE
PROCESS IMMEDIATELY and refer to the operation manual.
Keep the charger well away from dust, damp, rain, heat, direct
sunshine and vibration. Never drop it.
The allowable DC input voltage is 11-18V DC.
The allowable AC input voltage is 110
V
or
220V
AC.
This charger and the battery should be put on a heat-resistant,
non-ammable and non-conductive surface. Never place them on
a car seat, carpet or similar surface. Keep all ammable volatile
materials away from the operating area.
Make sure you know the specications of the battery to be
charged or discharged to ensure it meets the requirements of this
charger. If the program is set up incorrectly, the battery and
charger may be damaged. Fire or explosion can occur due to
overcharging. This warranty is not valid for any damage or
subsequent damage arising as a result of a misuse or failure to
observe the procedures outlined in this manual.
To avoid short circuiting between the charge lead, always connect
the charge cable to the charger rst, then connect the battery.
Reverse the sequence when disconnecting.
Never attempt to charge or discharge the following types of
batteries:
A battery pack which consists of different types of cells (including
different manufacturers)
A battery that is already fully charged or just slightly discharged
Non-rechargeable batteries (pose an explosion hazard)
A faulty or damaged battery
A battery tted with an integral charge circuit or a protection circuit.
WARNING AND SAFTEY NOTE