Ultra electronics MAGICARD 300 Installation Manual Download Page 1

Page: 1 / 4

www.ultramagicard.com

300 & Sprinter dye-film installation guide

To remove the dye-film carrier turn the “Dzus”
fastener ring a quarter turn counter-clockwise,
the dye film carrier can then be removed.

Remove the roll of dye film from its wrapper
and slide it over the bottom feed core.

Also fit an empty take up roll over the top core.

Important:-

Ensure the two locating notches are facing to
the left on both the top and bottom rolls, as
shown in diagram right>>>.

Notches

Replace the Film Carrier, with the empty take up
spool facing the top.

Summary of Contents for MAGICARD 300

Page 1: ...carrier can then be removed 1 Remove the roll of dye film from its wrapper and slide it over the bottom feed core Also fit an empty take up roll over the top core Important Ensure the two locating not...

Page 2: ...the spool locate correctly with the locking pins Manually turn the Spur Gear until the notches on the spool engage with the locking pins 4 Turn the Dzus Fastener 1 4 turn clockwise to lock in place L...

Page 3: ...d with your hands Feed the leading edge of the dye film over the top of the Thermal Printhead and beneath the guide bar stick the leading edge on the dye film to the take up spool with the white label...

Page 4: ...e the dye film and take up spools ON PRINTERS WITH WHITE PLASTIC DYE FILM TAKE UP GEAR Remove the steel pin which normally engages with the recess in the dye film take up spool This pin is a press fit...