AX-48 PRO SERIES SETUP
AX-48 PRO SERIES SETUP
While pushing the release button under the foot cap, pull out support
legs, then flip leg out until it snaps into place. Repeat with the other
two support legs. Turn the knob on the fourth leg and extend to floor for
greater stability.
Screw handle into the bottom and
top sliding handle brackets. Do not
tighten all the way, handle should
be able to slide up and down. Slide
handle into desired position on stand
and tighten screws completely. If the
handle needs to be moved, loosen
screws and slide handle to the new
position and tighten screws again.
After loading top instrument, secure
cable in cable clips. Rotate cable clips
for re-positioning.
To accommodate larger, heavier keyboards
and/or lower playing styles, remove
the angle adapter. To remove the angle
adapter, remove all keyboards and lay
stand flat. Remove small screw and slide
out the angle adapter.
Position clamp on column face and install bracket and T-screw. (Angular
edge rides in column slot.) To Adjust, loosen T-screw and move to
desired position. Open top cap and remove Tribars. Attach Tribars to
clamps by Tribar hook. Push Tribar down into clamp receiver.
Three Support Legs
Legs should be flat
Handle
Screw
Screw
Sliding
Handle
Bracket
Sliding
Handle
Bracket
Small
Screw
Angle
Adapter
Release button
LEG SETUP
ATTACHING HANDLE
ADJUSTING CABLE CLIPS
USING ANGLE ADAPTER
ARM SETUP
Fourth Leg
1
2
3
1
2
3
Top Latch
T-Screw
Bracket
Arms
Clamp
