Ultimate
3
Fig. 2- Door installation
Fig. 4-
Grille
Speaker
Mounting
Ring
Mounting
Holes
Screw
Clips
Mounting
Screws
Mounting
Surface
Cut-out
U l t i m a t
e
4.
Connect the crossovers to your amplifier, mid-
woofer, and tweeter locations. The terminals are
marked for easy identification and to help you
observe the correct polarity. Just insert the wire
ends into the terminal slots, and secure the
connection by tightening the terminal screws.
IV.
Installation- Mid-Woofers
1.
Choose mounting locations for your Platinum
Format mid-woofers. Check for clearance behind
the speaker mounting locations, making sure the
speakers will not interfere with any handles,
window cranks, door locks, or brackets. If the
speakers are to be mounted in the vehicle doors,
check the operation of all functions(windows,
locks, and any other switches or hand cranks) to
make sure there is no obstruction. Be sure the
mounting location and the drilling of screw holes
for mounting will not present a hazard to any
wires, control cables, fuel lines, fuel tanks,
hydraulic lines, or other vehicle systems or
components. For rear deck installations, make sure
the speakers will not interfere with opening and
closing the trunk.
2.
If you are replacing an original factory speaker
with a speaker that is exactly the same size, you
may not need to cut or drill any new holes or run
any additional wires. Simply connect the speakers, observing correct polarity, and mount
the speakers in the factory location, using the original mounting cut-outs, screw holes and
hardware. You probably will not need the grilles and mounting rings for replacement
installations.
3.
Use the supplied
template as a guide to
cut the proper
diameter mounting
holes. Use the
template or mounting
ring to mark the
locations for the
mounting screws and
drill the holes with a
1/8” diameter bit
.
4.
Feed the speaker wire
from the crossover W+
and W- terminals
through the opening and mounting ring, and connect it to the speaker terminals. Make
sure you maintain the correct polarity. The supplied speaker wire is marked to help you
maintain correct polarity when making connections.
The terminals at one end of the speaker wire are
coded by size to match the speaker terminals. Just
push the connectors onto the matching terminals.
+
-
+
-
+
-
TWEETER
WOOFER
AMPLIFIER
Ultimate
Tweeter
Output Level
Mounting Holes
Mounting Holes
-2 0 +2
+
-
Speaker Terminals
