Pull the valve and twist
Valve when mattress is fla
t
Valve showing the LEFT turn symbol
Mattress Setup
Secure the mattress to the moving parts of the
mattress platform
using the securing straps, and when the system is fully inflated it
is ready for the patient to be positioned onto the mattress.
Lay the mattress on the bed patient surface ensuring that the air
pipe connector is situated on the bottom left hand side of the bed
foot end (as viewed from the foot of the bed).
Security Straps
There are security straps fitted to the base cover of the mattress
which should be fastened loosely to convenient points on the
bedframe patient surface.
Ensure when fixing the mattress to the bed the security straps
are only fitted to the moving parts of the mattress platform.
Image showing 3 of 6 straps. All 6 straps should be fastened
Issue
5
07
/202
1
UPRA3678DT-2.QRG-
5
A Full
R
isk
A
ssessment should be completed before using this System
-
Please refer to User Manual for guidance
www.ultimatehealthcare.co.uk | Tel: 0333 321 8996
Cable Management System
Cable management fixings are
located on each side of the mattress underneath the flap of the
cover. The mains power cable should be secured through the
cable management fixing as follows:
•
Locate each cable
management fixing.
•
If necessary, open the press
studs.
•
Run the mains power cable
along the side
of the mattress
securing each fixing loop
around the cable using the
press studs.
Ensure power cable the air output
pipe are routed in such a manner
so that they cannot be twisted, trapped, crushed or stressed.
Connecting the Mattress to the Pump
Remove the cover of the air pipe connector and connect the
air pipe connector to the Pump
. When turning the power on,
the pump goes directly into auto firm to inflate the mattress.
When fully inflated it reverts to the initial setting of 10 minutes.
At this point the comfort control can be set to the desired weight
or activate the auto detection.
Setting up the pump
Whilst holding the pump, unfold the
hanging hooks on the rear of the Pump
and hang it from the bed’s footboard.
Activation of
Timed
Turning Function
The
T
urning Function
Activation of Manual Turn
Assist Function
1)
Select
CLP mode on pump panel
2)
Select
the chosen turn valve to turn position
3) The mattress will inflate and remain in turn position until
deactivated
4) To deactivate return valve to flat position
5) Repeat process for opposite turn if required
____________________________________________________________________________________________________________
1)
Select Alternating mode on Pump panel
2)
Select Turn time / Cycle time
3)
Select the chosen turn valve and open to the turn
position
4)
Repeat the process for opposite side if bilateral
turning
is required