Tips and Trouble Shooting
Storage or Transport
Tip the Dip Station over
on it's side
Depress the front and
rear locking tabs located
between each set of
rubber feet and evenly
pull the two dip station
halves apart.
Depress the upper
locking tabs and fold legs
in toward one another
until they lock with a click
Difficult / Kinked Assembly
To prevent kinking or jamming during the assembly of
the two halves (Assembly Step #3), be sure to insert
both bar end sections at the same time and guide them
together evenly until both lock into place with a click.
If problems persist, apply a light amount of lubricant to
both the tapered ends of the tubing.
If you encounter difficulty assembling the two halves,
please contact customer service for assistance:
877-734-7227
Difficult Disassembly
To prevent kinking or jamming the tubes be sure to
separate the two cross bar sections evenly.
If a connection does become jammed, try rocking or
swiveling the pieces to free them.
Typically, it becomes easier to separate the bar sections
after a few uses.
Contact customer service for assistance:
877-734-7227
Stability During Use and Leveling
The Dip Station can be used on hard or carpeted
surfaces. Very minor play in the assembly is normal and
the Dip Station stabilizes under weight while in use.
Stability can be further enhanced by leveling the Dip
Station. Simply rotate the rubber feet to increase or
decrease height at each of the four corners.
Each foot has 8 different
height positions.
Summary of Contents for DIP BAR
Page 2: ......