Ultima EPulse Elite, Manual

Page: 5 / 19

Safety During Installation and/or Maintenance
Do not attempt to lift without assistance.
Clean the enclosure with “armor all” or like substance with soft cloth
Any service on this equipment that requires removal of any covers can expose parts which
involve the risk of electric shock or personal injury. Make sure that the POWER ON/OFF
switch is at OFF position and the device is disconnected from the main power source. Refer
such service to qualified personnel.
Do not replace any of the components with parts not specified for use on this manual.
How to Replace the Fuse
Make sure the POWER ON/OFF switch is in the OFF position and the device is
disconnected from the wall power outlet. The device requires a
​ 4-amp fuse ​ and the fuse
compartment is located at the bottom of the AC receptacle. To open the fuse compartment,
fill the gap (pointed by
​ red arrow ​ ) with a small slotted screw driver, then pull it out. To
replace the compartment, simply press it back in. ​ Refer to Figure 1 below.
​
Figure 1
If you have any problems with the device or accessories, contact an Authorized
distributor’s representative.
Electrical Safety
To reduce the risk of electrical shock, this device uses a three-wire AC power cord to
connect the device to earth-ground. To preserve this safety feature:
a. Make sure the INPUT VOLTAGE marked on the device (see Figure 1) matches the
power voltage in your area. DO NOT attempt to toggle the POWER ON/OFF switch to
ON position if the INPUT VOLTAGE of the device and the voltage in your area DO
5